Prior To Initial Operation; Suction Power Control; Dry Vacuum Cleaning - SPARKY HeavyDuty VC 1530SP Manual De Instrucciones

pRIoR to INItIAl opERAtIoN

▪ Make sure power supply voltage corresponds
to the value indicated on the name plate with
technical data of the appliance.
▪ If the supply cord is damaged it must be re-
placed with a special cord or assembly avail-
able from the manufacturer or its service agent
to avoid a safety hazard.
▪ It is absolutely necessary for you to read, under-
stand, and observe the section entitled "Safety
instructions for vacuum cleaners".
▪ Prior to initial operation the operating staff must
be instructed on the appliance correct usage,
trained and informed on the risks associated
with the material to be picked up and the safe
disposal of the collected material.
filter bag /
Dust class m Disposal bag /
filter element
Dust with OEL
values
≥ 0.1 mg/m
3
(observe any
additional national
regulations)
Wood dust and
concrete dust

sUctIoN poWER coNtRol

The suction power can be adjusted by rotating
the switch lever (4) to allow optimum adaptation to
various operations (Fig. 10, Fig.11).

DRy vAcUUm clEANING

WARNING: Never vacuum up hazard-
ous materials.
Always insert a fleece filter bag or a disposal bag
into the tank prior to dry vacuum cleaning. Thus
the disposal of the vacuumed material is conve-
nient and hygienic.
ImpoRtANt! The filter element is damp after wet
vacuum cleaning. A damp filter clogs more quickly
Original instructions
when dry vacuum cleaning. For this reason the fil-
ter should be washed and dried or replaced with a
dry one prior to dry vacuum cleaning.
▪ Make sure that the appliance is not plugged into
vc 1530sp, vcm 1530sp - Remove the upper
section (Fig.13), fit the fleece filter bag (16) into the
tank (Fig.14a) and press firmly its hard carton in-
sert to the inlet fitting (Fig.14b) taking care not to
damage the fleece filter bag.
vc 1530sA, vcm 1530sA - Remove the upper
section (Fig.13) and insert the disposal bag (18)
into the tank (2). Check that the disposal bag ven-
tilation openings v remain inside the tank and
press its hard carton insert firmly to the inlet fit-
ting. Fold the top edge of the disposal bag over the
tank rim (Fig.15).
▪ Place the upper section back on the tank and
Cat. №
▪ Insert the larger end of the hose into the tank
Disposal bag
(5 pcs.)
▪ Select the necessary nozzle or aluminium ex-
Cat. №
20009642304
▪ Plug in the vacuum cleaner (Fig.19).
Fleece filter bag
(5 pcs.)
▪ Place the switch (4) to position "I" to switch the
Cat. №
20009642204
▪ When you have completed vacuuming, switch
PET cartridge filter
(1 pc.)
Cat. №
20009642500
Check the fleece filter bag regularly and replace it
when it is 2/3 full. The filter bag is designed in such
Flat filter
(2 pcs.)
way that only air, and no dust, can pass through
Cat. №
the material. Therefore a used filter bag shall not
20009642401
be reused.
NotE: Do not use the fleece filter bag or the dis-
posal bag for vacuuming up objects with sharp
edges or wet objects.
IMPORTANT! After wet cleaning the filter
must be washed and dried or replaced with a
dry one before dry cleaning again.
bag or a disposal bag for wet cleaning.
AUtomAtIc moDE WItH poWER tools
▪ Unplug the vacuum cleaner.
▪ Open the clamps (10) and remove the upper
▪ Check to make sure that the tank (2) is free of
the power supply (Fig.12).
clip the clamps (Fig.16).
front inlet and lock in place (Fig.17).
tension tube (VC 1530SP) and connect it to the
free hose end (Fig.18).
motor on (Fig.20).
the motor off by shifting the switch (4) to posi-
tion "o" and unplug the cable.
WARNING: Never use a fleece filter
section (7).
dust and dirt.
7
EN