Descargar Imprimir esta página

Air Filter Maintenance; Spark Plug Service - Stiga TRE 0701 Manual De Instrucciones

Ocultar thumbs Ver también para TRE 0701:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 52
6
EN
«MAX» notch on the dipstick (3).
g)    C lose  the  cap  (1)  again  and  clean  up  any 
traces of oil that was possibly spilt.
IMPORTANT
The engine holds a maxi-
mum of 1.2 litres of oil. Topup gradually adding
small amounts of oil at a time; check that the oil
level never exceeds the «MAX» notch on the
dipstick.
6.4 CLEAN SILENCER AND ENGINE
Silencer  must  be  cleaned  when  the  engine  is 
cold.
a)    U se  a  jet  of  compressed  air  to  remove  any 
debris and dirt that could cause a fire from the 
silencer and its protective cover.
b)    M ake sure that the cooling air intakes (1) are 
not blocked.
c)    C lean  the  plastic  components  with  a  sponge 
(2) soaked in water and detergent.

6.5 AIR FILTER MAINTENANCE

a)  Clean the area around the filter cover (1).
b)    R emove the cover (1) by unscrewing the two 
knobs (2 - TRE0701 - TRE0801), or by press-
ing the  tabs (2a - TRE0702).
c)    R emove the filtering element (3a + 3b).
d)    R emove  the  pre-filter  (3b)  from  the  cartridge 
(3a).
e)    T ap  the  cartridge  (3a)  on  a  solid  surface  and 
blow it from the inside with compressed air to 
remove dust and debris.
f)    W ash the sponge pre-filter (3b) with water and 
detergent and leave it to dry in the air.
IMPORTANT
Do not use water, petrol,
detergents or any other products to clean the
cartridge.
IMPORTANT
The sponge pre-filter (3b)
must NEVER be oiled.
g)    C lean  the  inside  of  the  filter  housing  (4)  from 
dust and debris, making sure to block the inlet 
duct with a rag (5) to prevent them from enter-
ing the engine.
h)    R emove the rag (5), install the filtering element 
(3b + 3a) in its housing and refit the cover (1).

6.6 SPARK PLUG SERVICE

a) Remove the spark plug (1) using a spark plug 
socket wrench (2).
b)    C lean  the  electrodes  (3)  with  a  metal  brush 
and remove any carbonaceous build-up.
c)    U sing  a  thickness  gauge  (4),  check  for  the 
right  gap  (0.6  -  0.8  mm)  between  the  elec-
trodes.
d)    I nstall  the  spark  plug  (1)  and  tighten  with  a 
socket wrench (2).
Replace the spark plug if the electrodes are burnt 
or if  the porcelain is broken or damaged.
WARNING!
the ignition system with spark plug re mo­
v ed.
IMPORTANT
Use only spark plugs of the
recommended type (see 8.1).
Fire hazard! Do not check

Publicidad

loading

Este manual también es adecuado para:

Tre 0702Tre 0801