Main Components; Assembly; Assembly Components; Assembly Of The Guide Bar And Toothed Chain - Stiga PR 500 Li 48 Manual De Instrucciones

IMPORTANT The example of the
Declaration of Conformity is provided
on the last pages of the manual.

3.4 MAIN COMPONENTS

The machine is composed of a series
of main components that have the
following functions (fig.1):
A. Motor: supplies the drive power
to the cutting means.
B. Front hand grip: support hand grip
located on the front of the chainsaw. This
should be grasped using the left hand.
C. Rear hand grip: support hand grip located
on the rear of the chainsaw. This should be
grasped using the right hand. This hand
grip is fitted with the main throttle controls.
D. Front hand guard: protection device seated
between the front hand grip and the toothed
chain, to protect the hand against injuries
should it slip off the hand grip. This guard is
used as a device to trigger the chain brake.
E. Fastening point: coupling device
used to fasten the chainsaw to a rope
or belt, and then hook it onto the
operator's harness using clasp clips.
F. Guide bar: supports and
guides the toothed chain.
G. Toothed chain: cutting element,
consisting of drive links fitted with
small blades called "teeth" and side
connections held in place by rivets.
H. Chain restraint pin: safety device that
prevents uncontrolled movements of the
toothed chain should it break or slacken.
I. Spiked bumper: device installed
opposite the guide bar assembly
point acting as a pivot when it comes
into contact with a tree or trunk.
J. Spiked bumper guard: spiked
bumper cover to be fitted during
handling, transportation or storage
of the machine. This guard must be
removed when using the machine.
K. Bar cover guard: chainsaw cover on the
guide bar to be fitted during handling,
transportation or storage of the machine.
L. Battery: device that supplies electric current
to the tool; its specifications and regulations
for use are described in a specific manual.
M. Battery charger (accessory available
upon request, par. 15.2): device
used to recharge the battery.

4. ASSEMBLY

The safety regulations to follow
are described in chap. 2. Strictly
comply with these instructions to
avoid serious risks or dangers.
For storage and transport purposes, some
components of the machine may not be installed
in the factory and have to be assembled after
unpacking. Follow the instructions below.
Unpacking and completing the assembly
should be done on a flat and stable surface,
with enough space for machine handling
and its packaging, always making use of
suitable equipment. Do not use the machine
until all the instructions provided in the
"ASSEMBLY" section have been carried out.

4.1 ASSEMBLY COMPONENTS

The packaging holds the components needed
for assembly as listed in the table below:
Guide bar fitted with bar cover
Toothed chain
Key
Documentation
4.1.1 Unpacking
1. Carefully open the packaging, paying
attention not to lose components.
2. Consult the documentation in the
box, including these instructions.
3. Remove all the unassembled
parts from the box.
4. Remove the machine from the box.
5. Dispose of the box and packaging in
compliance with local regulations.
4.2 ASSEMBLY OF THE GUIDE
BAR AND TOOTHED CHAIN
Always wear heavy duty gloves when
handling the bar and chain. Mount the
bar and chain very carefully so as not to
impair the safety and efficiency of the
machine. If in doubt, contact your dealer.
Perform all operations after
removing the battery.
Before assembling the bar, check that
the chain brake is not engaged (par. 5.4).
EN - 7