Safety Signs; Identification Label; Main Components - Stiga CS 80 Li Manual De Instrucciones

– sectioning pallets, crates and
various packing materials;
– sectioning furniture or other materials with
nails, screws or other metal components;
– butchering meat;
– using the machine to cut materials
other than wood (plastic materials,
building materials);
– using the machine to lift,
move or split objects;
– using the machine while
fastened to fixed supports;
– using cutting means other than those
found in the "Technical Data" table.
Serious injury and wound hazard.
– use of the machine by more
than one person.
IMPORTANT Improper use of the machine
will invalidate the warranty, relieve the
Manufacturer from all liability, and the user
will consequently be liable for all and any
damage or injury to himself or others.
3.1.3 User types
This machine is intended for use by
consumers, i.e. non-professional operators.
The machine is intended for "DIY" use only.

3.2 SAFETY SIGNS

The machine has various symbols on it
(fig. 2). They are used to remind the operator
of the behaviour to follow to use it with
the necessary attention and caution.
Meaning of symbols:
Warning! Read the instructions
before operating the machine.
Warning! Failure to use this
machine correctly can be
hazardous for oneself and others
Danger! Make sure the chain does
not come into contact with foreign
bodies/obstacles.
Kickback may occur if the
chain comes into contact
with an obstacle
Danger! Always use
hearing protectors.
Danger! Wear eye protections.
Danger! Do not leave the machine
in the rain (or in damp conditions)
Beware of kickback! Kickback
is the rapid and uncontrollable
backward motion of the chain
saw in the direction of the
operator. Always work in complete
safety. Use chains with safety
links that limit kickback.
Warning! Never hold the
machine with one hand! Hold
the machine firmly with both
hands to control the machine and
reduce the risk of kickback.
IMPORTANT Any damaged or illegible
decals must be replaced. Order replacement
decals from an authorised service centre.

3.3 IDENTIFICATION LABEL

The identification label holds
the following data (fig. 1):
1. Sound power level
2. CE conformity marking
3. Year of manufacture
4. Type of machine
5. Manufacturer's reference model
6. Serial number
7. Name and address of Manufacturer
8. Article code
9. Guide bar lenght
Write the identification data of the
machine in the specific space on the
label on the back of the cover page.
IMPORTANT Quote the information on
the product identification label whenever you
contact an authorized service workshop.
IMPORTANT The example of the
Declaration of Conformity is provided
on the last pages of the manual.

3.4 MAIN COMPONENTS

The machine is composed of a series
of main components that have the
following functions (fig.1):
A. Motor: supplies the drive power
to the cutting means.
B. Front handgrip: support handgrip
located on the front of the chain saw. This
should be grasped using the left hand.
EN - 5