en Troubleshooting
Fault
Appliance has a humming
sound.
Appliance switches off dur-
ing use.
The programme does not
start.
The To-Go blade insert can-
not be connected to the
base unit.
42
Cause
The blade is blocked or stiff.
Processing quantity is too
great or processing time
was too long.
The rotary switch is not set
to .
The programme has been
cancelled using the pro-
gramme button.
Outlet protection is active.
troubleshooting
Set the rotary switch to .
▶
Remove the blockage.
▶
Set the rotary switch to .
▶
Reduce the processing quantity.
▶
Allow the appliance to cool down to
▶
room temperature.
Set the rotary switch to .
▶
Wait for three seconds.
1.
Set the rotary switch to .
2.
Press the programme button for the
3.
required programme.
Screw the To-Go blade insert and
▶
the To-Go blender jug in by turning
them in a clockwise direction.
a The To-Go blender jug and To-Go
blade insert are fully and tightly
screwed in.