Maintenance And Care - SATA dry jet 2 Instrucciones De Servicio

Ocultar thumbs Ver también para dry jet 2:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 61
connection nipple [1-5].
■ Turn the air flow control to the left
to adjust the required air flow.
■ Hold the dry jet gun in the re-
quired working position, making
sure it is aligned correctly (see
chapter 9.1).
■ To stop blowing, turn the air flow
control to the right as far as it will
go and disconnect the dry jet gun
from the compressed air circuit.
9.3. Stand version
Notice!
These operating instruc-
tions describe operations with
the SATA dry jet 2 stand with
height-adjustable holder and 2
dry jet guns (Art. No. 223008).
All other extensions and vari-
ations by SATA can be used
as alternatives. For example,
SATA dry jet 2 stand jumbo (Art.
No. 223503).
■ Set the stand up in the correct
position and alignment [4-4],
[4-9].
■ Connect the stand to the com-
pressed air circuit with the con-
nection nipple [4-3].
■ Turn the air flow control of the dry
jet guns to the right as far as it
will go.
■ Connect the dry jet guns [4-1],
[4-8] to the quick couplings
[4-2], [4-7] and align them cor-
rectly.
■ Turn the air flow control of the dry
Operating instructions SATA dry jet 2
jet guns to the left to adjust the
required air flow.
■ To stop blowing, turn the air flow
control of the dry jet guns to the
right as far as it will go, then take
the dry jet guns off the stand or
disconnect the stand from the
compressed air circuit.

10. Maintenance and Care

Warning!
Risk of injuries from compo-
nents coming loose
Components may come loose
unexpectedly when performing
maintenance to the dry jet gun
while this is still connected to the
compressed air circuit.
→ Always disconnect the dry jet
gun from the compressed air cir-
cuit before performing any main-
tenance work.
Spare parts are available for carry-
ing out repairs (see chapter 13).
10.1. Replace flat fan nozzle
Remove flat fan nozzle
■ Pull the flat fan nozzle [2-6] off
the front nozzle [2-7] of the dry
jet gun.
Insert the new flat fan nozzle
■ Push the flat fan nozzle [2-6]
onto the front nozzle [2-7] of the
dry jet gun until locks in place.
10.2. Replace connection
nipple
Remove connection nipple
EN
57

Publicidad

Tabla de contenido
loading

Tabla de contenido