Serta Motion Essentials Manual Del Usuario página 17

headboard bracket installation guide (divided king)
Headboard Brackets are an optional accessory and are not included.
A 9/16" & 1/2" socket and crescent wrench are necessary to complete installation.
STEP 1
a.) Align the hole in the bracket to the brass sleeve into which
the leg threads . Hold the bracket in place and screw the leg
into the base until it is snug . DO NOT OVERTIGHTEN . Too
much force may cause the leg to spin freely .
b.) Align the tab with the hole in the frame (located towards the
foot of the base) and use a short bolt and nut to secure the
bracket . Make sure the bolt is tight .
a
b
STEP 2
Attach the plastic spacer and T-Bracket .
a.) Measure the distance between the mounting holes on the
headboard and install the spacer and attachment plate to
accommodate the headboard .
b.) To install the plastic spacer and attachment plate, you will
need two (2) long bolts and two (2) nuts . Place the spacer
and attachment plate in the desired location and slip the bolts
through the holes with the head of the bolt facing outward .
Position the bolts diagonally on the spacer . Use the 9/16"
socket and wrench to tighten the bolts .
STEP 3
You may now connect your headboard to the attachment plates
using the remaining short bolts and nuts to secure it to the
brackets . The heads of the bolts will face outward . Use a 9/16"
socket and 1/2" wrench to tighten the bolts .
15