Pair Remote - Serta Motion Essentials Manual Del Usuario

pair remote

The original remote that comes in the box is already paired to the bed base.
In the event that the remote is not paired with the base, follow the steps below.
STEP 1
Remove back cover from remote
control . Remove and replace
batteries .
STEP 2
Double click the button on the
Power Down Box (this will not
cause the base to move) . The light
will illuminate .
If the Power Down Box is not available, double click the reset button on the control box . Pairing LED light on control box will
illuminate . Press and hold button on the back of the remote, the button will begin to blink . Both lights will become continuous
and then simultaneously turn off.
No further action is required.
STEP 3
Press and hold button on the back of the
remote. The light will begin to flash then
become a continuous solid light .
STEP 4
Both lights on the Power Down Box
and the remote will be continuous, then
simultaneously turn off. Replace back cover
of the remote .
The remote is now paired with the base .
11