Removing The Bath Lift - Invacare Aquatec Orca Manual Del Usuario

Bathlift Orca / Orca F / Orca XL
1. Place the seat (B) on the bottom of the empty bathtub. Ensure that
the spindle foot retainer (C) is pointing towards the end of the
bathtub opposite the drain (A).
2. Fold the side flaps of the seat outwards.
3. Place the backrest (A) (without the hand control) onto the seat so
that the hooks (B) of the backrest fit into the hinges (C) of the seat
plate (D).
IMPORTANT Risk of damage!

Damage to the product caused by the spindle foot slipping
out.
▸ Ensure that the spindle foot is fully retracted, before folding
up the backrest.
▸ Once the backrest is folded up, ensure that the spindle foot
is in the spindle foot retainer.
4. Hold the backrest at the center of the head end and carefully lift it
into the end position.
8
5. Plug the jack socket with the unlocking sleeve (C) on the spiral
cable (B) of the hand control (A) to the jack plug (D) until the
locking mechanism engages noticeably.

4.3 Removing the bath lift

1. Let the water out of the bathtub.
2. Lower the bath lift using the Down button until the backrest stops
in the lowered end position. See Section 5.2 Controlling the bath
lift.
3. Unlock the jack socket on the spiral cable of the hand control by
pushing up the unlocking sleeve and pull it off the jack plug.
IMPORTANT Risk of damage!

▸ When folding the backrest down, ensure that spiral cable of
the hand control does not become trapped.
▸ Do not fold the backrest down if there is water in the
bathtub.
Set up and installation