Package Contents; Description Of The Product; Fitting The Battery - Num'axes IKI SONIC Manual De Instrucciones

Package contents

- a collar equipped with a short bark sensor
- a nylon strap
- a slide buckle for the strap
- a 3 Volt CR 2450 lithium battery

Description of the product

Nylon strap
Orange mark:
Area where the magnet is located
to switch On/Off or change mode

Fitting the battery

- Remove the screws from the battery cover with a screwdriver.
- Remove the battery cover.
- Insert the 3 Volt CR 2450 lithium battery as indicated under the battery holder (See diagram 2).
- A sound beep is emitted indicating that the battery was properly inserted. If you do not hear any sound
beep after inserting the battery, immediately remove it from the battery holder by using the supplied
magnet (magnetic key) or by tapping briefly the case in the palm of your hand.
- Check the polarity before inserting the battery once again. If you still do not hear any sound beep,
check the operation by switching the collar On and Off.
- Replace the battery cover taking care to insert first the little pin at the bottom of the battery cover
(See diagram 3).
- Retighten moderately the 2 screws.
Diagram 2
« + » terminal of
the battery
downward
- a magnetic key (magnet)
- a long bark sensor
- a small plastic screwdriver (See Diagram 5)
- this user's manual
Sensor
(short or long)
Gb - 12
Diagram 1
Diagram 3
Replace the battery cover
taking care to insert first
the little pin at the
bottom of the battery
cover