Technical Data - Hilti SC 55W Manual De Instrucciones

5 Technical data

Right of technical changes reserved.
NOTE
When powered by a generator or transformer, the generator or transformer's power output must be at least twice the
rated input power shown on the rating plate of the power tool. The operating voltage of the transformer or generator
must always be within +5% and -15% of the rated voltage of the power tool.
Rated voltage
Rated power input
Rated current input
Mains frequency
NOTE
The electric supply voltage may drop briefly when this power tool is started, especially if the electric supply network is
of poor quality. These voltage drops may affect other appliances (e.g. lighting may flicker). Disturbances of this kind
are not to be expected in supply networks with an impedance of less than 0.454 Ω. (If necessary, please contact your
local electricity supply company for further information).
Power tool
Weight in accordance with EPTA procedure 01/2003,
with small base plate
Weight in accordance with EPTA procedure 01/2003,
with large base plate
Specified blade diameter
Saw blade disc thickness
Saw blade arbor size
Cutting depth
Speed under no load
NOTE
The sound pressure and vibration values given in these instructions have been measured in accordance with a
standardized test and may be used to compare one electric tool with another. They may be used for a preliminary
assessment of exposure. The data given represents the main applications of the electric tool. However, if the electric
tool is used for different applications, with different accessories or is poorly maintained, the data may vary. This may
significantly increase exposure over the total working period. An accurate estimation of exposure should also take into
account the times when the tool is switched off, or when it is running but not actually being used for a job. This may
significantly reduce exposure over the total working period. Identify additional safety measures to protect the operator
from the effects of noise and/or vibration, for example: maintain the electric tool and accessories, keep the hands
warm, organization of work patterns.
Noise information for the SC 55W (measured in accordance with EN 60745-2-5):
Typical A-weighted sound power level, L
Typical A-weighted emission sound pressure level, L
Uncertainty for the given sound level, K
Total vibration (vector sum of three directions), measured in accordance with EN 60745
Sawing wood, a
hW
Uncertainty, K
Other information about the power tool
Protection class
100 V
1,100 W
11 A
50...60 Hz
WA
pA
110 V
1,100 W
10 A
50...60 Hz
SC 55W
4.5 kg
4.7 kg
160...165 mm
1.1...1.5 mm
16 mm / 20 mm
Cutting angle 0°: 55 mm
Cutting angle 45°: 41 mm
Cutting angle 50°: 37 mm
5,500/min
100 dB (A)
89 dB (A)
3 dB (A)
2.2 m/s²
1.5 m/s²
Protection class II (double insulated), see rating plate
220‑240 V
1,200 W
5...5.5 A
50...60 Hz
17
en