Technical Data - Hilti SC 4WL-22 Manual De Instrucciones Original

Status
All LEDs show in sequence, followed by one (1)
LED quick-flashing yellow.
All LEDs show in sequence, followed by one (1)
LED showing constantly red.
3.6 Fence
Use of the single arm fence allows precise cuts to be made along the edge of the workpiece, or strips of
even width to be cut.
The fence can be fitted on either side of the base plate.
4

Technical data

4.1 Product
Rated voltage
Weight in accordance with
EPTA-Procedure 01, without battery
Saw blade diameter
Saw blade disc thickness
Kerf width
Saw blade arbor size
Rated speed under no load
Maximum cutting depth
Bevel cutting angle
Storage temperature
Ambient temperature for operation
4.2 Battery
Battery operating voltage
Weight, battery
Ambient temperature for operation
Storage temperature
Battery charging starting temperature
4.3 Noise information and vibration values in accordance with EN 62841
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure.
The data given represent the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools, or is poorly maintained, the data can vary. This can
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the total
working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration, for
example: maintaining the power tool and accessory tools, keeping the hands warm, organization of work
patterns.
26 English
Meaning
The check to ascertain the battery's state of health
did not complete. Repeat the procedure, or consult
Hilti Service.
If a connected product can still be used, the re-
maining battery capacity is below 50 %.
If a connected product can no longer be used, the
battery has reached the end of its useful life and
has to be replaced. Consult Hilti Service.
21.6 V
3.0 kg
160 mm ... 165 mm
0.5 mm ... 1.5 mm
1.5 mm ... 2 mm
20 mm
4,000 /min
57 mm
0° ... 50°
−20 ℃ ... 70 ℃
−17 ℃ ... 60 ℃
2276127
21.6 V
See the end of these
operating instructions
−17 ℃ ... 60 ℃
−20 ℃ ... 40 ℃
−10 ℃ ... 45 ℃
*2276127*