Aqua Medic easy line 190 Manual De Instrucciones página 8

Available spare parts: Please refer to www.aqua-medic.de.
2. Set-Up
To fix the unit to a wall, disconnect the two wall brackets from the module and fix them directly on the wall or a
mounting plate - preferably near a tap connection. Press module into the brackets - ready.
Then, mount the membrane and connect the tubes. To avoid any failures, follow the instructions carefully:
The connections of the unit are (please refer to Fig. 1):
8
Tube fittings:
1. Remove the blue lock ring.
2. Insert the hose to a complete stop into the fitting.
3. Refit the lock ring.
4. Pull the hose back as a test that it is located.
Release the plug connection:
1. Remove the blue lock ring.
2. Push the white ring at the fitting. Now, you can remove the tube.
3. Please don't forget to refit the lock ring.
Fig. 1:
1. Water inlet
2. Fine filter
3. Activated carbon filter
4. Reverse osmosis module
5. Pure water outlet
6. Waste water outlet incl.
flush valve
7. Module's screw cap
8. Membrane
9. O-rings
10. Flush valve