Flex S 703 BVE Manual De Instrucciones página 8

MAINTENANCE
KEEP TOOL CLEAN
Periodically blow out all air passages with dry, compressed air. All plastic parts should be
cleaned with soft damp cloth. NEVER use solvents to clean plastic parts. They could
possibly dissolve or otherwise damage the material.
CAUTION: Wear safety glasses while using compressed air.
FAILURE TO START
Should your tool fail to start, check to make sure the prongs on the cord plug are making
good contact in the outlet. Also, check for blown fuses or open circuit breakers in the line.
LUBRICATION
This tool has been lubricated with a sufficient amount of high grade lubricant for the life of
the unit under normal operating conditions. No further lubricant is necessary.
BRUSH INSPECTION AND LUBRICATION
For your continued safety and electrical protection, brush inspection and replacement on
this tool should ONLY be performed by an Authorized Service Agent for FLEX Power Tools.
At approximately 100 hours of use, take or send your tool to your nearest Authorized
Service Agent for FLEX Power Tools to be thoroughly cleaned and inspected; worn parts
replaced, and when necessary; relubricated with fresh lubricant, if required; reassembled
with new brushes; and performance tested.
Any loss of power before the above maintenance check may indicate the need for
immediate servicing of your tool. DO NOT CONTINUE TO OPERATE TOOL UNDER THIS
CONDITION. If proper operating voltage is present, return your tool to the Service Agent for
immediate service.
SERVICE AND REPAIRS
All quality tools will eventually require servicing or replacement of parts due to wear from
normal use. These operations, including brush inspection and replacement, should ONLY be
performed by an AUTHORIZED Service Agent for FLEX Power Tools. All repairs made by these
agencies are fully guaranteed against defective material and workmanship. We cannot
guarantee repairs made or attempted by anyone other than these agencies.
Should you have any questions about your tool, feel free to write us at any time. In any
communications, please give all information shown on the nameplate of your tool (model
number, type, serial number, etc.).
4