Operation - Minipa MFA-845 Manual De Instrucciones

5) OPERATION

Before making any measurement, read the "SAFETY INFORMA-
TION" section with attention and remember of all warnings. A lways
check the instrument regarding damages, contamination (excessive
dust, grease, ...) and defects.
Check the test leads against cracks or defects in the insulation. In
the case of any abnormal condition is detected, do not take any
type of measurement
1. Press ON/OFF button to turn on the instrument. All LEDs flash
during 2 seconds. Only the power LED stays light up. Do not
use the instrument where any LED no light up.
2. Use the " " marker of alligator clip in the center of conductor
in each measurement. Connect the clips as follows:
Red to L1, Phase-R
White to L2, Phase-S
Blue to L3, Phase-T
White
Blue
Red
Figure 2
14
R, L1
S, L2
T, L3