Diagram Showing How To Place The Flexible Pipes; Installing On Boiler; Preparations For Start Up - baltur BTL 4P Manual De Instrucciones

DIAGRAM SHOWING HOW TO PLACE THE FLEXIBLE PIPES

* The two flexibles hoses shall be positioned as show on the figure for ensuring correct closing of the cover, they can come out
from the lower side or the left side of the burner.

INSTALLING ON BOILER

when attaching the burner to the flange position the
combustion head axis as illustrated in the diagram (angle α).

PREPARATIONS FOR START UP

Control that the nozzle (60° spray angle) applied is suitable for the
boiler popentiality.
The table shown delivery rates in kg/h of light oil with respect to the
nozzle size and the pump pressure (normally 22 bar for the 2nd
flame). It should be remembered that 1 kg of light oil in equivalent
to approximately 10.200 kcal. Make sure that the return pipe in the
tank has no obstructions, e.g. gate valves, closed plugs etc. Any
eventual obstruction would cause a breakage in the sealing surface
situated on the pump shaft. Close the main switch and the boiler
thermostats in order to start up the motor and the ignition transformer
and, after approximately 10 seconds, the electric valve will out in and
expose the photoresistant cell to a source of light until the burner
stops (shut down).
When the pipelines have been filled up (and when fuel has come
out of the nozzle), stop the burner and put the photoresistant cell
back in its seat.
Should it be necessary to purge air, this can be done by
loosening the special fitting which the pump is provided with
(see 8945/2). Do not illuminate the photoresistant cell before
the electric valve has out in because, in this case, the control
box will go to "shut down".
7 / 16
0006080762_201309
WITH SLIDING FLANGE:
• Fasten flange (B) to the boiler
with n°4 screws (D) placing the
insulation card (E);
• Insert burner into flange / boiler
and tighten screw (A) with nut (C).