Stihl RT 5097 Manual De Instrucciones página 44

Guide the retaining pins (1) into the bores
in the mounting (2). Insert the cotter pin (3)
into the retaining pin bores from above and
allow to engage.
● Repeat this procedure on the other
side.
Tensioning the V-belt (RT 5097,
RT 5097 C, RT 5097 Z):
Pull the tension spring (1) forwards and
attach to the mowing deck as shown.
42
Tensioning the V-belt (RT 5112 Z,
RT 6112 C, RT 6112 ZL, RT 6127 ZL):
Press the V-belt tensioner lever (1)
forwards and hold in place. Detach the
retainer (2).
Tension the V-belt by relieving the load on
the V-belt tensioner lever (1). Attach the
retainer (2) to the V-belt tensioner lever (1)
as shown.
Installing the V-belt cover:
Press the retaining plate (1) forwards and
hold in place. Fold the V-belt cover (2)
upwards. Guide the retaining plate (1) to
the rear and engage at the two retaining
tabs (3) on the V-belt cover.
Fasten the retaining plate in place using
the screw (1).
● Install the discharge chute. (
0478 192 9809 A - EN
15.6)