Tabla de contenido
Publicidad
Manual de instrucciones
Gateway UNIVERSAL para el diagnóstico de serie
10.
Descripción de los módulos de bus de campo
Front View
10.1
PROFINET IO
#
Item
1
Network Status LED
2
Module Status LED
3
Link/Activity LED
4
Ethernet Interface
Network Status LED
Note: A test sequence is performed on this LED during startup.
LED State
Off
Green
Green, flashing
Module Status LED
Note: A test sequence is performed on this LED during startup.
LED State
Off
Green
Green, 1 flash
Green, 2 flashes
Red
Red, 1 flash
Red, 2 flashes
Red, 3 flashes
Red, 4 flashes
LINK/Activity LED
LED State
Off
Green
Green, flickering
Ethernet Interface
The ethernet interface operates at 100Mbit, full duplex, as required by PROFINET.
1
Description
Comments
Offline
- No power
- No connection with IO Controller
Online (RUN)
- Connection with IO Controller established
- IO Controller in RUN state
Online (STOP)
- Connection with IO Controller established
- IO Controller in STOP state
Description
Comments
Not Initialized
No power - or - Module in 'SETUP' or 'NW_INIT' state
Normal Operation
Module has shifted from the 'NW_INIT' state
Diagnostic Event(s)
Diagnostic event(s) present
Blink
Used by engineering tools to identify the node on the network
Exception Error
Module in state 'EXCEPTION'
Configuration Error
Expected Identification differs from Real Identification
IP Address Error
IP address not set
Station Name Error
Station Name not set
Internal Error
Module has encountered a major internal error
Description
Comments
No Link
No link, no communication present
Link
Ethernet link established, no communication present
Activity
Ethernet link established, communication present
ES
About the Anybus-CompactCom PROFINET IO 1-2
1
8
2
4
3
SD-I-U-...
9
Publicidad
Tabla de contenido
