Technical Data; Before Starting The Machine; Fuel And Oil - EINHELL Expert GE-PH 2555 A Manual De Instrucciones

Anleitung_GE_PH_2555_SPK7__ 29.10.12 07:15 Seite 15

4. Technical data

Engine type:
2-stroke engine, air-cooled, chrome cylinder
Engine output (max.):
Displacement:
Idle speed of engine:
Max. engine speed
Weight (with empty tank):
Cutting length:
Cutting capacity (max.)
Spark plug:
Max. cutting speed
Sound and vibration
Sound and vibration values were measured in
accordance with ISO 3477, ISO 11201.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Vibration emission value (front handle)
Vibration emission value a = 6.41 m/s
h
K uncertainty = 1.5 m/s 2
Vibration emission value (rear handle)
Vibration emission value a = 6.24 m/s
h
K uncertainty = 1.5 m/s 2
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Additional information for electric power tools
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
n
0.85 kW / 1.15 hp
order.
24.5 cm 3
Service and clean the appliance regularly.
n
3300 min -1 Adapt your working style to suit the appliance.
n
Do not overload the appliance.
n
8000 min -1
Have the appliance serviced whenever
n
5.4 kg
necessary.
Switch the appliance off when it is not in use.
55 cm n
Wear protective gloves.
n
19 mm
Champion RCJ7Y
Residual risks
Even if you use this electric power tool in
1900 cuts/min
accordance with instructions, certain residual
risks cannot be rules out. The following hazards
may arise in connection with the equipment's
construction and layout:
1. Lung damage if no suitable protective dust mask
is used.
2. Damage to hearing if no suitable ear protection is
used.
98.9 dB(A)
3 dB

5. Before starting the machine

104.5 dB(A)
3 dB
5.1 Assembly
The hedge trimmer is supplied fully assembled. No
assembly work is required.
2
To make it easier to control, the machine is fitted with
a rotary handle that can be adjusted as required into
positions at angles of -90°/0°/+90°. To do this, press
the lever (Fig. 5/Item B) downwards, turn the rotary
2
handle into the required position and then allow the
lever to rise and latch in place again. The various
adjustable positions facilitate working above head
height or in other places with different access.
Important: The rotary handle may only be adjusted
when the engine is switched off.

5.2 Fuel and oil

Recommended fuels
Use only a mixture of normal unleaded petrol and
special 2-stroke engine oil. Mix the fuel mixture as
indicated on the fuel mixing table.
Please note: Do not use a fuel mixture which has
been kept for longer than 90 days.
Please note: Do not use 2-stroke oil with a
recommended mixing ration of 100:1. If inadequate
GB
15