Adjustments; Seat Adjustment - Bremshey Sport Sprinter Control Manual Del Usuario

•
Do not attempt any servicing or
adjustments other than those described
in this guide. Everything else must be left
to someone familiar with the maintenance
of electromechanical equipments and
authorised under the laws of the country in
question to carry out maintenance and repair
work.
•
The emergency brake can be used to stop
the flywheel immediately by pushing slightly,
to prevent any unwanted motion.
NOtE ABOUt
ASSEMBLING tHE
EQUIPMENt
Start by unpacking the equipment. The
detailed assembly instructions can be
found at the back of this guide. Follow the
instructions in given order.
Before assembly, check the contents of the
package. If a part is missing, please contact
your dealer with the model, equipment serial
no. and spare part no. of the missing part.
You'll find a spare part list at the back of this
guide. The hardware kit contents are marked
with * in the spare parts list. The directions
left, right, front and back are defined as
seen from the exercising position. Keep the
assembly tools, as you may need them e.g.
for adjusting the equipment. Note that two
people are needed for the assembly.
The packaging includes a silicate bag for
absorbing moisture during storage and
transportation. Please dispose of the bag
once you have unpacked the equipment.
Allow at least 100 cm of clearance around
the equipment. We also recommend opening
the package and assembling the product on
a protective base.
SAVE tHIS INStRUCtION MANUAL
O W N E R ' S M A N U A L

ADJUStMENtS

SEAt ADJUStMENt

Set the right height for you; the basic rule is
that the arch of the foot reaches reaches the
the pedal at its lowest point with the leg almost
straight. Adjust the seat height by loosening
the seat locking knob on the side. Hold on to
the seat with one hand and, using your other
hand, pull the locking knob outwards in order
to enable free seat tube movement upwards
and downwards. Once the height is right, let go
of the knob and the seat locks into place. Turn
the locking knob clockwise to tighten.
Always make sure that the locking knob is
NOtE!
properly fastened before starting to exercise!
To adjust horizontal seat position forward and
back, loosen the locking knob under the seat
by turning it clockwise. Adjust the seat to the
desired position and tighten the locking knob
by turning it counter-clockwise.
Do not pass the maximum border for the
NOtE!
seat. This can cause damage to the machine.
HANDLEBAR SEtUP
Loosen the locking knob on the side of the
handlebar support then loosen the knob on the
front side of the handlebar, and find the right
position. Tighten the locking knobs. The design
of the handlebar allows you to exercise either
in an upright position or with the upper body
leaning forward. Remember, however, always to
keep your back straight.
To assemble the bottle holder, put the bottle
holder on the mounting bracket with the 2
bolts. (with supplied allen key)
To assemble the monitor, first put in the
batteries, then connect the sensor wire. And
finally click the monitor onto the bracket on the
handlebar (see also assembly instructions on
page 43)
Always make sure that the locking knob is
NOtE!
properly fastened before starting to exercise!
ADJUStMENt OF SUPPORt FEEt
If the equipment is not stable, adjust the
adjustment screws below the support feet as
necessary.
G B
•
S p R I N T E R
3