Flue Connection; Important - Lamborghini Caloreclima Reply 51 Instrucciones De Uso

Reply 51 - 71 - 101

2.5 Flue connection

Important

The unit is a B23 type with combustion air drawn from the installation room and fume exhaust by means of a fan (oper-
ation with flue pressurised) and must be connected to one of the discharge systems indicated below. Before proceeding
with installation, check and carefully comply with the local regulations and provisions. Also comply with the provisions
concerning the positioning of wall and/or roof terminals and minimum distances from windows, walls, ventilation open-
ings, etc.
Manifold, ducts and flue must be suitably sized, designed and made in compliance with current regulations. These must
be made of suitable materials, i.e. resistant to heat and corrosion, smooth on the inside and hermetic. In particular, joints
must be condensate tight. Also provide for suitable condensate drain points, connected to a trap to prevent the conden-
sate formed in the flues from running into the generators.
B
The unit is equipped with two separate Ø80 flue connections for the two burner - exchanger units (fig. 28) lo-
cated inside the cabinet.
The combustion circuits of the two units are completely independent. When joining the two fume outlets to a
single flue or manifold (in case of a single module or connection in cascade) it is necessary to install a fume
anti-backflow valve on each outlet to prevent operation anomalies or to creation of hazardous conditions.
Make sure to use the optional kits Lamborghini, provided with special anti-backflow valves for installing inside
the cabinets, in a position protected against the atmospheric agents.
A
Before carrying out the flue connection, make sure to fill the condensate tank as indicated incap. 2.6 "Conden-
sate drain".
EN
700
250 200 250
Ø80 Ø80
fig. 28
cod. 3540H322 - 09/2008 (Rev. 01)
71