Basic Operation; Tips About Auto Mode - AERMEC Plasmacluster EWA-H Manual De Instrucciones

BASIC OPERATION

TIPS ABOUT AUTO MODE

In the AUTO mode, the temperature set-
ting and mode are automatically selected
according to the room temperature when
the unit is turned on.
Modes and Temperature Settings
Room temp.
Automatic Operation
at operation
Mode Temperature Setting
start-up
Below 21°C HEAT
21°C-24°C DRY Room Temp. at start-up
24°C-26°C COOL
26°C-28°C COOL
Above 28°C COOL
1
2
2
5
3
3
1
4
4
23°C
5
24°C
25°C
26°C
E-8
Press the MODE button to select
the operation mode.
AUTO HEAT
Press the ON/OFF button to start
operation.
• The red OPERATION lamp (
unit will light.
Press the TEMP. button to set the
desired temperature.
AUTO/DRY MODE
The temperature can be changed in 1°C
increments within the range of 2°C higher
to 2°C lower from the temperature auto-
matically determined by the air conditioner.
COOL/HEAT MODE
The temperature can be set within the
range of 18 to 32°C.
Press the FAN button to set the
desired fan speed.
AUTO SOFT LOW
• In the DRY mode, the fan speed is pre-
set to AUTO and cannot be changed.
To turn off the unit, press the ON/
OFF button again.
• The red OPERATION lamp (
unit will turn off.
COOL DRY
) on the
HIGH
) on the