Section Page; General Maintenance - Hitachi Koki CB 13F Manual De Instrucciones E Instrucciones De Seguridad

English

GENERAL MAINTENANCE

WARNING
For your own safety, turn switch OFF and remove the
plug from power source receptacle before
maintaining, cleaning, adjusting, or lubricating your
band saw.
To avoid fire or toxic reaction, never use gasoline,
naphtha, acetone, lacquer thinner or similar highly
volatile solvents to clean the band saw.
To avoid eye injury from blowing debris, wear safety
goggles when blowing out sawdust.
BAND SAW
Sawdust will accumulate under the table and base. This
could cause difficulty in the movement of the table when
setting up a band saw cut, and also cause a fire hazard.
Frequently blow out or vacuum up the sawdust.
Keep your band saw clean. Remove the sawdust from the
inside. Vacuum or blow out frequently.
Do not allow filth to build up on the table, the guides, or
the support bearings. Clean them with gum and pitch
remover.
NOTE: Do not immerse the support bearing in the gum
and pitch remover.
Put a thin coat of paste wax on the table so that the wood
slides easily while cutting.
TO INSTALL A NEW BELT (Fig. Y)
1. Open the lower wheel door.
2. Loosen the blade tension by turning the blade tension
lock knob (1).
3. Remove the blade from the lower blade wheel.
4. Loosen and remove the hex head blot (2) and flange
(3) on the lower blade wheel.
5. Remove the lower blade wheel.
6. Turn the belt tension handle (4) on the rear of the saw
housing to loosen the v-belt tension.
7. Remove the v-belt (5).
8. Check the alignment of the two pulleys.
9. If the edges of the two pulleys are not aligned, see:
ALIGN THE PULLEYS" in ADJUSTMENT section.
10. Place the new v-belt on the saw pulley and the motor
pulley. See OPERATION section "CHANGING SPEED
SETTINGS" on page for proper belt placement.
11. When positioned properly, tighten the v-belt tension
by turning the tension lock handle.
NOTE: The pulley belt is properly tensioned when there is
1/2"deflection if pressed in the center between the
pulleys.
12. Replace the blade wheel. Push the wheel on firmly
until it is touching the saw pulley. Replace and tighten
the flange and nut.
13. Reinstall the blade (See INSTALLLING BLADES
Section on page ).
14. Adjust the blade tension, tracking, and the upper and
lower blade guides and bearings before operating the
band saw.
MAINTENANCE
To avoid injury, the blade tension, tracking, and upper and
lower guides and bearings must be properly adjusted
before operating the band saw. (See ADJUSTNEBT
INSTRUCTIOONS section)
Fig. Y
BLADE WHEEL TIRES
Pitch and sawdust that build up on the tires should be
removed with a stiff brush or scrape off with a piece of
Wood.
NOTE: To avoid damaging the tires do not use a sharp
knife or any kind of solvent.
When the tires become worn they should be replaced.
When replacing the tires, stretch them around the wheels
but do not glue then on.
MOTOR
Frequently blow or vacuum out any sawdust from the
motor. Follow lubrication instruction on the motor label.
To avoid electrocution or fire, immediately replace a worn,
cut or damaged power cord.
LUBRICATION
All of the bearings are packed with grease at the factory.
They require no further lubrication.
CAUTION: Never put lubricants on the blade while it is
spinning.
— 20 —
WARNING
1
4
5
WARNING
3
2