Service And Repairs - Hitachi NH 90AB Instrucciones Y Manual De Seguridad

English
5. WARNING LABEL
Change the WARNING LABEL if missing
or damaged.
A new WARNING LABEL is available from
a Hitachi authorized service center.
Warning
label
6. Maintenance chart (See page 16)
7. Operator troubleshooting (See page 17)
8. Service parts list
CAUTION
Repair, modification and inspection of
Hitachi Power Tools must be carried out
by a Hitachi Authorized Service Center.
This Parts List will be helpful if presented
with the tool to the Hitachi Authorized
Service Center when requesting repair
or other maintenance. In the operation
and maintenance of power tools, the
safety regulations and standards
prescribed in each country must be
observed.
Maintenance chart
ACTION
Drain air line filter daily.
Keep lubricator filled.
Keep rod working
properly.
Lubricate the Nailer after
nailing.
Drain air compressor.
MODIFICATIONS:
Hitachi Power Tools are constantly being
improved and modified to incorporate the
latest technological advancements.
Accordingly, some parts may be changed
without prior notice.

SERVICE AND REPAIRS

All quality Nailers will eventually require
servicing or replacement of parts because
of wear from normal use.
NOTE:
WHY
Prevent accumulation of
moisture and dirt.
Keep the Nailer lubricated.
Promote operator efficient
Nailer operation.
Extend the Nailer life.
Keep the Nailer operated
properly.
— 16 —
WARNING
Only service personnel trained by
Hitachi, distributor or employer shall
repair the Nailer.
Use only parts
recommended by Hitachi for repair.
Specifications are subject to change
without any obligation on the part of
HITACHI.
Open manual petcock.
Fill with Hitachi pneumatic
tool lubricant.
Blow clean daily.
Supply 10 drops min. of
lubricant into the Nailer.
Open petcock on air
compressor tank.
supplied or
HOW