Important Safety Instructions For Using Nailers - Hitachi NH 90AB Instrucciones Y Manual De Seguridad

English
1. OPERATORS AND OTHERS IN WORK AREA MUST WEAR SAFETY GLASSES WITH SIDE
SHIELDS.
When operating the Nailer, always wear safety glasses with side shields,
and make sure others in work area wear safety glasses, too.
Safety glasses must conform to the requirements of American National
Standards Institute, ANSI Z87.1 and provide protection against flying particles
both from the front and side.
The employer must enforce the use of safety glasses by the Nailer operator
and others in work area.
2. NEVER USE OXYGEN OR OTHER BOTTLED GASSES. EXPLOSION MAY OCCUR.
Never use oxygen, combustible gases or any other bottled gases as a power
source for the Nailer.
Use of the above gases is dangerous, as the Nailer will explode.
Use only clean, dry, regulated compressed air.
3. NEVER POINT TOOL AT YOURSELF OR OTHERS IN WORK AREA.
Always assume the Nailer contains fasteners.
Never point the Nailer at yourself toward yourself or others, whether it
contains fasteners or not.
If fasteners are mistakenly driven, it can lead to severe injuries.
Never engage in horseplay with the Nailer.
Respect the Nailer as a working implement.
4. DO NOT EXCEED 120 psi. (8.3 bar 8.5 kgf/cm
SAFETY
IMPORTANT SAFETY INSTRUCTIONS
FOR USING NAILERS
READ ALL INSTRUCTIONS
Do not exceed maximum recommended air pressure 120 psi (8.3
bar 8.5 kgf/cm
Never connect the Nailer to pressure which potentially exceeds
200 psi (13.7 bar 14 kgf/cm
DANGER
WARNING
2 )
2
).
2
) as the Nailer can burst.
— 4 —