Contents Of Package; Inserting The Batteries In The Remote Control - Carrera RC Nintendo Mini Mario-Copter Instrucciones De Montaje Y De Servicio

Instruction Manual

Contents of package

1 1 x Quadrocopter
1 x Controller
1 x USB charging cable
1x Rechargeable Battery
2 x 1.5 V Mignon AA batteries
(non-rechargeable)
Recharging the LiPo rechargeable
battery
Make sure you only charge the LiPo recharge-
able battery supplied with the LiPo charging
unit also supplied (USB cable and remote
control). If you try to charge the rechargeable
battery with a different LiPo battery charger
or any other battery charger, this might cause
serious damage. Please carefully read the
previous chapter with warnings and guide-
lines on the usage of rechargeable batteries
before proceeding. Supply terminals are not
to be short-circuited.
You can charge the rechargeable battery fit-
ted in the Quadrocopter with its USB charging
cable from a USB port on a computer:
Charging via computer:
2a
• Rechargeable batteries are to be removed
from the model before being charged.
• Connect the USB charging cable with the
USB port of a computer. The LED on the
USB charger cable lights green indicating
that the charger unit is correctly connect-
ed to the computer. If you plug in a Quad-
rocopter with a discharged battery, the
LED on the USB charging cable no longer
lights up, showing that the Quadrocopter
battery is being charged. The USB charg-
ing cable and the charging socket on the
Quadrocopter are designed to make in-
correct connection impossible.
• It takes about 60 minutes to recharge a
discharged battery (but NOT a deep-dis-
charged one). When the battery is fully
charged, the LED display on the USB
charger cable lights up green again.
ENGLISH
Note: when supplied, the lipo-battery is al-
ready partially charged. So the first charg-
ing cycle may well take less time.
It is essential to follow the connection se-
quence given above!
Undo the plugged connection on the
Quadrocopter when you are not using the
Quadrocopter. Failure to observe this pre-
caution may cause battery damage!
Insertion of the rechargeable batteries
2b
into the Quadrocopter
• Open the cover of the battery compartment
with the aid of a screwdriver. Insert the bat-
tery. Close the battery compartment.
• If the LED on the Quadrocopter flashes
slowly, you must change the battery.
Inserting the batteries in the
remote control
3 Open the battery compartment with a screw-
driver and insert the batteries in the remote
control. Please keep in mind the correct po-
larity. Different types of batteries or new and
used batteries are not to be mixed. After
having closed the compartment you can
check all functions of the remote control with
the help of the power-switch on the front.
With the power switch turned ON and
functioning correctly, the top centre LED
on the remote control will light up red. If
the LED control flashes slowly and an
acoustic signal is heard, the batteries in
the controller must be changed.
Frequency bind between model
and remote control
4
The Carrera RC Quadrocopter and the
controller automatically link up renewed
with every operational start-up. If initially
there are any problems with communica-
tion between the Carrera RC Quadrocop-
ter and the remote control, please carry
out a new frequency bind.
18