Carrera RC Nintendo Mini Mario-Copter Instrucciones De Montaje Y De Servicio página 19

• Connect the battery in the model.
• Switch the model ON at the ON/OFF switch.
• WARNING! Immediately after switch-
ing it on, place the Quadrocopter on
a flat and level surface. The gyro-sys-
tem will then set itself automatically.
• The LEDs on the quadrocopter now flash
rhythmically.
• Switch on the controller at the power switch.
• Slide the left joystick, thus the gas lever,
completely up and down again into the
zero position.
• The binding has now been successfully
established.
• The LED on the controller now lights
continuously.
• After approx. 5½ minutes, the controller
switches off. Please repeat the link pro-
cedure for renewed use.
Description of the Quadrocopter
5
1. Rotor system
2. Rotor protection cage
6 3. Battery cable
4. Quadrocopter connecting plug
5. Battery compartment
6. ON-/OFF switch
Range of functions of the remote
control
7 1. Power (ON / OFF)
2. Control LED
3. Gas
Circling
4. Forwards / backwards
right / left banking
5. Trimmer for right / left banking
6. Trimmer for forwards / backwards
7. Trimmer for rotation
8. Start rotor' button
9. 'Auto-landing' button
10. 'Auto-start & fly to 1 m' button
11. Beginner/Advanced switch
(30%/60%/100%)
3 12. Battery compartment
Choosing the flight area
8 When being prepared for the first flight
you should choose a closed room
which is as large as possible without
any persons or obstacles. Due to its
size and controllability, experienced pi-
lots may be able to fly the Quadrocop-
ter in relatively small rooms. For your
first flights we strongly recommend
you choose a room with a minimum
floor space of 5 x 5 metres and 2.40
metres in height. After having trimmed
your Quadrocopter for flight and made
yourself familiar with the controller and
its functions you may start flying in
smaller and less open environments.
To be used in domestic area (house and
garden) only. There must be no persons
or objects such as pillars between the
controller and the Quadrocopter to ob-
struct direct connection.
Checklist for flight preparation
This checklist is not a substitute for the con-
tents of the operating instructions. Although it
can be used as a quick-start-guide, we strong-
ly recommend you first to read the operating
instructions in detail before you proceed.
• Check the contents of the package.
• Connect the charging unit to the source of
power.
• Charge the lipo-battery as described in the
section "Recharging the LiPo rechargeable
battery".
• Fit 2 AA batteries in the controller, making
sure their polarity is correct.
• Look for a suitable environment for flying.
• Slide the battery into the battery bay on the
bottom of the Quadrocopter.
• Connect the battery in the model.
• Switch the model ON at the ON/OFF switch.
• WARNING! Immediately after switching it
on, place the Quadrocopter on a flat and
level surface. The gyro-system will then
set itself automatically.
• The LEDs on the quadrocopter flash.
19
ENGLISH
2b