Securing Your Baby - asalvo master-FIX 15181 Manual De Instrucciones

EN
INSTRUCTIONS
WARNING
Please use the baby insert attached to this car seat
whenyour baby 's weight is less than 15kg.
the baby insert is used to provide extra comfort for
very small babies, and it gives your baby the necessary
support while he or she is still small.
• Always secure your baby in the car seat using the harness.
• Never leave your baby unattended in the car seat when placing it on elevated
surfaces (e.g. a table, nappy changing unit, etc.).
• Never allow the strap end to become caught in moving parts (e.g. automatic
doors, escalators, etc.).
• Caution! The plastic parts of the car seat heat up in the sun, so that your baby may
get burnt. Protect your baby and the car seat against intensive solar radiation
(e.g. by putting a light cloth over the seat).
• Take your baby out of the car seat as often as possible to relieve its spine. We
recommend frequent breaks during long journeys. Even outside of the car, please
avoid leaving your baby in the car seat for too long.
IMPORTANT
the correct belt height of the shoulder belts is attained when the belt
disappears into the shell slightly above the shoulder of the child.
Make sure that the shoulder belts fit properly over the shoulders of the
child.
1
adJustinG tHe Belts
loosen the harness straps by
pressing the release button and
pulling the harness straps as far
as you can.
Note! do not pull the shoulder
pads.

SECURING yOUR BABy

Baby insert