Serial Numbers - Peg-Perego VIAGGIO1 DUO FIX TT Instrucciones De Uso

How to adjust the height of the head rest
The head rest must be adjusted to match the child's
height. There are 7 positions.
25• To change from a lower position to a higher one:
pull the strap in the upper central part of the headrest
upwards. The headrest will move at the same time.
To change from a higher position to a lower one:
pull the strap in the upper central part of the headrest
upwards and, at the same time, push the headrest
down to the desired position.
When you have finished, try moving the headrest
to check it is properly attached.
2 6• When the straps are positioned correctly, the child's
shoulders will be just below the point where the straps
pass.
2 7• IMPORTANT: The straps must not be too high or too
low with respect to the child's shoulders.
2 8• The Viaggio 1 Duo-Fix TT child seat can be reclined into
5 positions.
To recline the seat, press the lever under the seat (fig. a)
and pull this towards you to the desired position (fig. b).
How to remove the lining
To remove the lining of the Viaggio 1 Duo-Fix TT child
seat:
• Remove the head hugger, where present (point 24).
• Unfasten the safety straps (point 17).
• Open the rear cover.
29• Unfasten the straps from the rear support.
30• Unfasten the safety straps on the rear and slip them out
from the front.
31• Unfasten the shoulder straps on the rear and slip them
out from the safety straps from the front.
32• Slip off the string (fig. a) and then remove the headrest
from above (fig. b).
33• Below the frame, unfasten the leg divider (fig. a) and
remove the strap from the fabric leg divider (fig. b).
34• Slip the strap out through the slit in the fabric and
remove the lining, as shown in the figure.
Maintenance of the padding
Brush the fabric parts to remove dust.
• Machine wash at a maximum of 30°C with a delicate
wash setting and short spin cycle.
• Do not use chlorine bleach.
• Do not iron.
• Do not dry clean.
Do not remove stains with solvents.
• Do not tumble dry.
°
30
How to replace the lining on the
Viaggio 1 Duo-Fix TT car seat
To replace the lining of the Viaggio 1 Duo-Fix TT
To replace the lining of the Viaggio 1 Duo-Fix TT child
seat:
3 5• From below, slip the safety straps back in through the
slit in the fabric.
• Reinsert the strap into the fabric leg divider.
36• Fasten this into the hole in the frame.
3 7• attach the strip to the attachment point of the leg
divider strap
3 8• thread the lining starting from the seat and moving
upwards, paying attention to the shape of the backrest.
3 9• Slip the headrest back on, ensuring the red tab passes
through the slit in the fabric.
• Slip the shoulder straps into the safety straps.
4 0• Insert the safety straps in the seat in this order: begin
with the buckle of the shoulder straps and then deal
with the straps.
4 1• extend the straps and insert them in the seat's frame
(the straps in the upper hole, the buckle in the lower
one).
42• Fasten them correctly on the rear, as shown in the figure.
• Fasten the safety straps from the front (point 20).
IMPORTANT: The straps must not be twisted.
43• Open the rear cover and fasten the straps onto the rear
support.
• For infants, reposition the head hugger.

Serial numbers

4 4• The name of the product, production date and serial
29