Functional Description; Special Product Features; Commissioning; Additional Handle - Metabo SX E 425 TurboTec Instrucciones De Manejo

17026838_0707 SXE Turbo NAFTA.book Seite 7 Dienstag, 10. Juli 2007 11:27 11
~
...........alternating current
n ..........no load speed
0
../min ....revolutions per minute
rpm ......revolutions per minute
opm ......oscillations per minute

4 Functional Description

See page 3 (please unfold).
1 Sanding disc
2 Support plate
3 Additional handle (removable)
4 Knurled screw
5 Setting wheel for selecting oscillating
frequency
6 TurboBoost switch
7 Locking button for continuous activation
8 Trigger switch
9 Locking button for
"Duo" oscillating circuit setting *
10 Hexagon spanner
11 Button for removing the dust collection box
12 Dust collection box
13 Cleaning flap
14 Fluted filter
15 Locking screw for support plate
16 Braking ring of support plate brake
* depends on model

5 Special Product Features

• TurboBoost switch: allows you to switch on
additional power reserves for maximum material
removal rate
• Rotary and additional vibrational motion of
support plate for optimised sanding
• Variospeed (V) Electronics
• Setting wheel for selecting oscillating frequency
• No sanding scores when applying the running
machine to the material (Power Control System)
• Removable additional handle
• Dust-protected ball bearing
• Own extraction system
• External extraction possible
ENGLISH

6 Commissioning

Before plugging in, check to see that the
rated mains voltage and mains frequency,
as stated on the rating label, match your
power supply.
6.1

Additional handle

The removable additional handle (3) can be
screwed onto the machine with the integrated
knurled screw (4).
If required, insert a Phillips screwdriver in the hole
at the end of the additional handle to release or
tighten the knurled screw (4).
6.2

Installation of sanding disc

Simple attachment and removal thanks to the
velcro-type fastening.
Simply press on the sanding disc such that the
holes in the sanding disc (1) are aligned with the
support plate (2).

7 Use

7.1 Duo oscillating circuit setting

(only with SXE 450 TurboTec)

You can choose between two oscillating
frequency settings:
• Oscillating circuit high setting (6.2 mm): coarse
sanding with high material removal rate
• Oscillating circuit low setting (2.8 mm): fine
sanding, polishing
Changing oscillating circuit:
- Disconnect the mains plug!
- Press in the locking button (9) and hold in place.
- Rotate support plate (2) in a counter-clockwise
direction until you can hear it engage.
- Continue holding in the button.
- Continue turning the support plate half a revolu-
tion to the next snap-in point.
- Release the locking button.
7.2

On/Off switch, continuous activation

To start the machine, press the trigger switch (8).
For continuous operation the trigger switch can be
locked using the lock button (7). To stop the
machine, press the trigger switch (8) again.
ENG
7