Flotec 3601A Serie Manual Del Usuario página 4

Operation • Service
For automatic operation, plug or wire pump into an
automatic float switch or pump controller. Pump will run
continuously when plugged directly into an electrical
outlet. Connect or wire pump to its own individual
branch circuit with no other outlets or equipment in
the circuit. Size fuses or circuit breakers according to
Specifications chart.
Risk of electric shock . Can shock, burn or
kill. Be sure that power supply information (Voltage/
Hertz/Phase) on pump motor nameplate matches
incoming power supply exactly. Install pump according
to all electrical codes that apply.
Operation
NOTICE Do not allow pump to run in a dry sump. It will
void the warranty and may damage the pump.
An automatic overload protector in the motor will protect
motor from burning out due to overheating/overloading.
When motor cools down, overload protector will
automatically reset and start motor.
If overload trips frequently, check for cause. It could be
a stuck impeller, wrong/low voltage, or electrical failure
in motor. If an electrical failure in the motor is suspected,
have it serviced by a competent repairman.
Pump is permanently lubricated. No oiling or greasing
is required.
WARNING
Risk of electrical shock .
Can burn or kill.
Do not lift pump by power
cord.
For parts or assistance, call Flotec Customer Service at 1-800-365-6832.
Service
or kill. Before removing pump from basin for service,
always disconnect electrical power to pump and
control switch.
or kill. Do not lift pump by power cord. See Cord Lift
Warning below.
Submerge pump in a disinfectant solution (dilute chlorine
bleach) for at least one hour before disassembling pump.
The pump motor contains a special lubricating oil which
should be kept clean and free of water at all times.
Check operation by filling sump with water and
observing pump operation through one complete cycle.
and/or property damage. Failure to make this operational
check may lead to flooding and premature failure.
NOTICE This unit is not designed for applications
involving salt water or brine! Use with salt water or brine
will void warranty.
Cord Lift Warning
Risk of electric shock . Can shock, burn
Risk of electric shock . Can shock, burn
Risk of flooding . Can cause personal injury
1. Attempting to lift or support pump
by power cord can damage cord and
cord connections.
2. Cord may pull apart, exposing bare
wires with possibility of fire or
electrical shock.
3. Lifting or supporting pump by power
cord will void warranty.
4. Use lifting ring or handle on top
of pump for all lifting/lowering of
pump. Disconnect power to pump
before doing any work on pump
or attempting to remove pump
from sump.
4