Whirlpool SPIW409A2WF Instrucciones De Uso página 11

Maintenance
Clean front panel of Indoor Unit
1. Disconnect from the power supply
Turn off the appliance first before disconnecting from power supply.
2. Remove the front panel
Open the front panel as shown by the arrow (Fig. A).
Pull the slots at the side of the front panel with force to take out the front
panel (Fig. B).
3. Clean the front panel
Wipe it with a soft and dry cloth. Use lukewarm water (below 40°C) to clean
if the appliance is very dirty. After cleaning let it dry.
4. Refit and close the front panel
Refit and close the front panel by pushing it downward.
Note:
• Do not use substances such as gasoline or polishing powder to clean
the appliance.
• Do not sprinkle water onto the indoor unit Dangerous! Electric shock!
Clean Air filter
It is necessary to clean the air filter after using it for about 200 hours. Clean
the air filter every two weeks if the air conditioner operates in an extremely
dusty environment.
1. Disconnect from the power supply
Turn off the appliance first before disconnecting from power supply.
2. Take out air filter (Fig. C).
1. Open the front panel. 2. Press the handle of the filter gently. 3. Slide out
the filter.
3. Cleaning the air filter (Fig. D)
If the filter is very dirty, clean it with a solution of lukewarm water and
neutral detergent.
After cleaning let it dry.
4. Refit the filter, press the filter reset button (Fig.E) at right side by using
a cylinder pin and close the front panel.
Note:
• To avoid injury, do not touch the fins of indoor unit with your fingers
after removing the filter.
• Do not attempt to clean the inside of the air conditioner by yourself.
• Do not clean the filter in washing machine.
EMERGENCY OPERATION
Under emergency situation or when remote
control is missing, you can control the unit
by pressing the on/off swith located on the
indoor unit.
• Turn on the appliance: when the unit is off,
press this button, it will start up and operate
in 6 SENSE mode.
th
• Turn off the appliance: when the unit is on,
press this button, the unit will stop working.
Note: Do not press this button for a long
time as it will cause malfunction.
Auto-Restart Function
If you want to set auto-restart, switch on the power supply, press the ON/OFF button on the indoor unit and hold for
over 5 seconds, auto-restart is set with buzz sound.
If the auto-restart has been set, press the ON/OFF button on the indoor unit and hold for over 5 seconds, auto-restart
function will be cancelled with a buzz sound and air conditioner is on standby mode.
Disposal of the batteries
To protect natural resources and to promote material reuse, please separate batteries from other types of waste and
recycle them through your local, free battery return system.
Filter Reset button
on/off switch
- 11 -
on/off switch
Fig. A
Fig. B
Fig. C
Fig. D
Fig. E