Remote Controller - Whirlpool SPIW409A2WF Instrucciones De Uso

Remote controller

Insert the batteries into RC
1. Insert a pin and gently press down on the battery
cover and push in the direction of the arrow to
remove, as shown.
2. Insert 2 AAA batteries (1.5V) into the compartment.
Ensure that "+" and "-" polarity is correctly positioned.
3. Close the battery cover on the remote control.
• Remote Control presetting
Each time the batteries are replaced in the remote
controller, the remote controller pre-set at Heat Pump
mode. The heat pump AC remote controller can be used
to control the cool only AC models.
Note: please follow the intruction which matches to the remote controller you receive for Air Conditioner operation.
Function description of buttons (P1-04)
1. ON/OFF BUTTON
Starts or Stops the appliance by
pressing this button.
3. FAN BUTTON
Used to select fan speed in sequence
auto, high, medium or low.
4-5. TEMPERATURE BUTTON
Used to select the room
temperature.
Used to set the time in timer mode.
6. 6 SENSE BUTTON
th
Sets or cancels 6
th
7. SWING BUTTON
Stops or starts horizontal adjustment
louver swinging and sets the desired
up/down airflow direction.
10-11. HUMIDITY BUTTON
Used to set desired humidity level,
they areonly available under 6
SENSE mode.
16. SUPER SILENT BUTTON
Used to start or stop the super
silent operation to have a low noise
environment.
Symbols on RC display
Cooling indicator
Humidity plus indicator
Humidity minus indicator
Fan only indicator
Heating indicator
Around U indicator
Jet indicator
sense operation.
th
Auto fan speed
High fan speed
Medium fan speed
Low fan speed
Super silent indicator
6 SENSE indicator
th
Power save indicator
Use RC to control the appliance
• To operate the appliance by remote control, point the
remote control at the receiving device on the indoor
unit, to ensure receiving sensibility.
• To send a message from remote control, the symbol
will flash for 1 second. On receipt of the message,
the appliance will emit a beep.
Signal receptor
• The remote control will operate the air conditioner at a
distance of up to 7m.
• Each time the batteries are replaced in the remote
control, the remote control is pre-set at Heat Pump
mode.
Sleep indicator 1
Sleep indicator 2
Sleep indicator 3
Sleep indicator 4
Display set temperature
Display set timer
ON
OFF
Signal transmission
- 9 -
2. MODE BUTTON
Used to select the operation mode
in sequence Cooling, hearing or
fan.
8. SLEEP BUTTON
Used to select the sleep mode in
sequence of sleep 1, sleep 2, sleep
3 sleep 4 and sleep off.
9. AROUND U BUTTON
Used to set or cancel Around U
function.
12. JET BUTTON
Used to start or stop the fast
cooling or heating.
13. DIM BUTTON
Used to turn on or turn off display
light on indoor unit.
14. POWER SAVE BUTTON
Used to start or stop the power
save operation.
15. TIMER BUTTON
Used to set the time for turn on or
turn off the appliance.
Active RC by pressing UNLOCK button
Press the button, the backlight
will be lighted up and function
buttons will be activated for
use. Press again to lock remote
controller. If no operation on
remote controller for 10s, the
remote controller will be locked
automatically.
PRESS