Fitting The Back To The Chair - Sunrise Medical JAY Zip Manual De Instrucciones

E N G L I S H
DETERMINING COMPATIBILITY
Wheelchair Types
The Zip Back is designed to be compatible with most wheelchairs
with the following exceptions:
Wheelchairs that are angularly adjustable, recline or tilt and result
in a back angle greater than 60 degrees from the vertical should not
be used.
Use with these types of wheelchairs may cause the
back to accidentally disconnect from the wheelchair
resulting in a fall and the potential for serious injury.
Wheelchair Dimensions
The JAY Zip back is designed to replace the wheelchair's sling
upholstery. Prior to installation determine if the wheelchair used
has c om patible back canes, by measuring the width between your
back canes as see n in Figure 1. Then using that measurement,
check Table 1 to determine if the back will fit your chair.
Next check that the back canes are a compatible diameter.
The JAY back hardware can be mounted on wheelchair
back canes ranging from 3/4" to 1 1/8". Measure your back
cane diameter (Fig. 2) and refer to Table 2 to ensure your
back canes are compatible.
If you cannot determine that the back canes are compatible
please contact your authorized Sunrise Medical provider
or Sunrise Medical customer service.
120688 Rev. B
WARNING

FITTING THE BACK TO THE CHAIR

A
Zip Back Width*
Minimum width
(all contours)
8"
10"
12"
14"
* Back Width is identified in your back's part number.
Example: JZIPB10S is a 10" wide back.
TABLE 2
Back Width
Minimum width
(all contours)
8" - 14"
5
A
Width of back canes from outside to
outside of the tubes (Fig. 1-A)
Maximum width
inch cm inch
7.7 19.6 9.3
9.7 24.6 11.3
11.7 29.7 14.3
13.7 34.9 16.3
Cane diameter (B)
Maximum width
i nch cm inch
3/4 1.9 1 1/8
1
Table 1
cm
23.6
28.7
36.3
41.3
2
cm
2.85