Additional Safety Warnings - MIRKA DEROS 550X CV Instrucciones De Manejo

Please read and comply with
• General Industry Safety & Health Regulations, part 1910, OSHA 2206, available from:
Superintendent of Documents; Government Printing Office; Washington DC 20402
• Safety Code for Portable Air Tools, ANSI B186 .1 available from:
American National Standards Institute, Inc .; 1430 Broadway; New York, New York 10018
• State and local regulations
WARNING
• Always wear required personal safety protection in accordance with manufacturer's instruction and local/national
standards while using this tool .
• The safety of the tool is ensured only by using original Mirka backing pads .
• Do not use a power tool if you are tired or under the influence of drugs, alcohol or medication .
• Read the Materials Safety Data Sheet (MSDS) for the working surface .
• Use the tool with dust extraction . A suitable dust extraction unit will reduce hazardous dust .
• Do not overreach . The operator must always stand in a secure position with a firm grip and firm footing on a solid
floor .
• Do not wear loose clothing or jewelry . Keep hair, clothing and gloves away from moving parts . Loose clothes, jewelry
or long hair can get caught in moving parts .
• If any physical hand/wrist discomfort is experienced, stop working and seek medical attention . Hand, wrist and arm
injury may result from repetitive work, motion and overexposure to vibrations .
• Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust .
Powertools may create sparks which may ignite the dust or fumes .
CAUTION
• Remove pad wrench before connecting the tool to the power source .
• Keep work area clean and well lit .
• Always ensure that the work piece to be sanded is firmly fixed in place .
• Before changing the abrasive always disconnect the power source . Make sure the abrasive is perfectly centered
and firmly attached to the backing pad .
• Keep children and bystanders away while operating a power tool . Distractions can cause you to lose control .
• Always pay attention to work safety . Never carry, store or leave the tool unattended with the power source connected .
• Keep hands clear of the spinning pad during use .
• Do not allow the tool to free speed without taking precautions to protect any persons or objects from the loss of the
abrasive or pad .

Additional safety warnings

• Read all instructions before using this tool . All operators must be fully trained in the proper, safe use of this tool .
• All maintenance must be carried out by trained personnel . For service, contact a Mirka authorized service center!
• Always use the tools with a residual current device (RCD) with a rated residual current of 30 mA or less .
• The power supply socket and connector are non-IEC appliance couplers . Only use an original Mirka power supply
cable . The Mirka power supply cable can be bought from your Mirka Dealer .
• Check the tool, backing pad, power cord and fittings regularly for wear .
• Clean or replace the vacuum unit dust collection bag daily . Dust can be highly combustible . Cleaning or replacing the
bag also assures optimum performance .
• Always ensure that the power tool specifications correspond to the power source (V, Hz) .
• Take care to avoid clothing, ties, hair, cleaning rags, etc ., from getting caught in the tool's moving parts .
• If the tool appears to malfunction, stop using it immediately and arrange for service and repair .
Compliance
This device complies with part 15 of the FCC Rules . Operation is subject to the following two conditions:
1 . This device may not cause harmful interference .
2 . This device must accept any interference received, including interference that may cause undesired operation .
Mirka® DEROS • 125 mm (5") & 150 mm (6") • 110 V
en
9