Clean The Sediment Lid; Changing The Fuel Filter (Hatz Motor); Important - ENAR ZEN SERIE Manual De Instrucciones

7.7 CLEAN THE SEDIMENT LID

7.7.1.
7.7.2.
7.7.3.
7.7.4.

7.8 CHANGING THE FUEL FILTER (HATZ MOTOR)

The maintenance intervals for the fuel pump filter depend on the purity of the diesel fuel that is used.
Where necessary, the interval should be reduced to 250 hours.
!
!
7.8.1.
7.8.2.
7.8.3.
7.8.4.
VIBRATING PLATES
Close the fuel valve.
Take out the sediment lid with the O-ring.
Wash them in non-inflammable solvent, dry and reinstall them firmly.
Open the fuel valve, check that there are no leaks and that the area is dry before
proceeding to start the engine up.
ATTENTION:
 When working on the combustion system, never expose it to naked flames without any
protection; do not smoke.

IMPORTANT:

 Make sure that jobs are carried out cleanly, so as to avoid any dirt from entering the
fuel pipe.
 Fuel particles may cause damage to the injection system.
Take the cover off the tank and remove the fuel filter from its housing inside the tank, with
the aid of the cord.
Unscrew fuel pipe "1" from filter "2" and fit a new filter.
Fit the filter back in place and replace the cover on the fuel tank.
The fuel injection system will commence purging automatically.
O-RING
SEDIMENT LID
ZEN / ZEN-E
en
23