Using Remote Control To Change Prosthesis Settings - Ottobock 4X350 Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 90
Prosthesis settings should be optimised using the adjustment software.
The remote control is not intended for use by the prosthetist to set up the
prosthesis. The behaviour of the prosthesis can be changed to a certain
extent on a day-to-day basis using the remote control (e.g. while becom­
ing accustomed to the prosthesis). The prosthetist can use the adjust­
ment software to trace these changes at the next appointment.
If the settings of a MyMode are to be modified, one must first switch to
this MyMode.

8.2.1 Using remote control to change prosthesis settings

INFORMATION
The number and names of the configurable parameters depend on the
respective prosthesis. Therefore, the illustrations of menus in this section
are by way of example only.
Further information on the parameters is found in the instructions for use of
the respective prosthesis.
12
1) Use the
,
main menu and confirm this with the  key.
→ A list appears with the parameters for the currently active mode
(see fig. 13).
2) Use the
,
with the  key.
→ A scale will appear in the display of the remote control and shows
the value currently set for the parameter as well as the parameter's
limit values (see fig. 14).
3) Use the ,  keys to change the parameter setting and confirm this with
the  key.
To leave the menu without saving changes, use the
the
 symbol and confirm this with the  key.
→ The message "Successful" appears briefly to confirm these
changes were saved in the prosthesis.
4) If necessary, switch off the remote control unit by selecting and confirm­
ing the menu option "RC power off".
32 | Ottobock
13
 keys to select the menu option "Device settings" in the
 keys to select the parameter you want and confirm this
14
,
 keys to select

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

4x350-x3

Tabla de contenido