Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
One For All 6-Device PVR Universal Remote Control
NOTE: Only one device can be assigned to
T
R
-A
D
: P
O
E
SSIGN
EVICE
ERFORM
DVD as 2nd TV key: SET - 9 - 9 - 2 - TV
- DVD
DVD as 2nd CBL/
SET - 9 - 9 - 2 -
SAT key:
CBL/SAT - DVD
DVD as 2nd PVR
SET - 9 - 9 - 2 - PVR
key:
- DVD
DVD as 2nd AUD
SET - 9 - 9 - 2 - AUD
key:
- DVD
device key by substituting it for the DVD
key above and performing the sequence.
For example, to re-assign an unused
AUD key as a second VCR key, perform
SET - 9 - 9 - 2 -VCR - AUD. When you've
will blink twice to confirm your choice.
At that time, you will need to program
the remote control for the new device
page 6).
CHANGING VOLUME LOCK
The One For All 6-Device PVR Universal
Remote Control (URC-6131n) is set
at the factory for independent volume
control of each selected device.
However, you may change the Volume
that a device's volume will be locked to
one mode (e.g., to control TV volume
in all other modes). After that, if
desired, you can perform Individual
Volume Unlock on a selected device to
set its volume control for independent
operation.
LOCKING VOLUME CONTROL TO ONE MODE
(GLOBAL VOLUME LOCK)
1. Press and hold SET
light) blinks twice, then release SET.
10
key once (e.g., TV
twice.
S
EQUENCE
3. Now, when you press VOL +, VOL -,
or MUTE, the volume of the selected
device (e.g., TV) will be controlled
regardless of the mode you have
selected.
UNLOCKING VOLUME CONTROL FOR A
SINGLE DEVICE (INDIVIDUAL VOLUME
UNLOCK)
1. After performing
(see above), press a desired mode
key where you want volume to be
unlocked (e.g., AUD) and controlled
within its own mode.
2. Press and hold SET
light) blinks twice, then release SET.
4. If desired, repeat steps 1 through 3 (of
this section) for each device that you
want volume to be unlocked.
5. Now, after you select a device that has
volume unlocked (e.g., AUD), pressing
VOL +, VOL -, or MUTE, will control the
device's volume only in its own mode.
UNLOCKING ALL VOLUME CONTROL
(RESTORING DEFAULT SETTING)
NOTE: Performing these instructions will
restore independent volume control for
all programmed devices (e.g., TV volume
control in TV mode, VCR volume in VCR
mode, etc.).
1. On the remote control, press and hold
SET
twice, then release SET.
3. Volume will again be independently
controlled according to its default
states for all programmed devices.
9 9 3 and then press any mode
9 9 3 and then press VOL - once.
9 9 3 and then press VOL + once.
Publicidad
Capítulos
Tabla de contenido
