Publicidad
Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
PVR 6 Owners Manual.fm Page 11 Monday, December 20, 2004 11:17 AM
3.
Press the destination mode twice
(where keymoved keys are stored). The
LED will blink twice.
RE-ASSIGNING DEVICE
KEYS
You can set the One For All 6-Device PVR
Universal Remote Control (URC-6131nw) to
control a second TV, PVR/DVR, VCR, DVD
player, or other device. For example, to
control a TV, a cable box, and two VCRs, you
will need to re-assign the unused DVD key to
operate the second VCR as follows:
1.
On the remote control, press and hold
SET until the LED (red light) blinks
twice, then release SET.
2.
Enter 9 9 2. The LED will blink twice.
3.
Press VCR once, then press DVD once.
The LED will blink twice.
4.
The DVD key is now ready to be
programmed for your second VCR. See
"Programming Device Control" on
page 6.
To re-assign other device keys to the DVD
key, repeat steps 1 through 4 with a
sequence from the below chart:
NOTE: Only one device can be assigned to an
unused device key at a time.
To Re-Assign
Perform Sequence
Device
DVD as 2nd
SET - 9 - 9 - 2 - TV -
TV key:
DVD
DVD as 2nd
SET - 9 - 9 - 2 -
CBL/SAT key:
CBL/SAT - DVD
DVD as 2nd
SET - 9 - 9 - 2 - PVR -
PVR key:
DVD
DVD as 2nd
SET - 9 - 9 - 2 - AUD -
AUD key:
DVD
O
WNER
You can also re-assign another unused
device key by substituting it for the DVD key
above and performing the sequence. For
example, to re-assign an unused AUD key as
a second VCR key, perform SET - 9 - 9 - 2 -
VCR - AUD. When you've completed the re-
assignment, the LED will blink twice to
confirm your choice. At that time, you will
need to program the remote control for the
new device (see "Programming Device
Control" on page 6).
CHANGING VOLUME LOCK
The One For All 6-Device PVR Universal
Remote Control (URC-6131nw) is set at the
factory for independent volume control of
each selected device.
However, you may change the Volume Lock
setting to Global Volume Lock so that a
device's volume will be locked to one mode
(e.g., to control TV volume in all other
modes). After that, if desired, you can
perform Individual Volume Unlock on a
selected device to set its volume control for
independent operation.
L
V
C
OCKING
OLUME
ONTROL TO
(G
V
L
)
LOBAL
OLUME
OCK
Press and hold SET until the LED (red
1.
light) blinks twice, then release SET.
2.
Enter 9 9 3 and then press any mode
key once (e.g., TV). The LED will blink
twice.
Now, when you press VOL +, VOL -, or
3.
MUTE, the volume of the selected
device (e.g., TV) will be controlled
regardless of the mode you have
selected.
Re-assigning Device Keys 11
'
M
S
ANUAL
O
M
NE
ODE
Publicidad
Capítulos
