Searching For Your Code; Checking The Codes - One for All URC6131N Manual De Instrucciones

2. On the remote control, press DVD.
Next, press and hold SET until the
release SET.
Combos (Códigos de Configuración
para Aparatos Combinados DVD/
locate the brand name and then enter
the first four-digit code for your
device. If performed correctly, the
NOTE:
repeat steps 2 through 4 and enter the
same code again.
4. Aim the remote control at the device
and press POWER once. It should
turn off. If it does not, repeat steps 2
through 4, trying each code for your
brand until you find one that works.
NOTE: If the device does not have a POWER
(PLAY
5. If you've located a setup code that
works, but it also has a separate VCR
code, you'll also need to program it
into the remote control to access VCR
controls as follows:
a. Press VCR once. Then press and
hold the SET
blinks twice.
VCR code for your DVD
Player/VCR Combo. If correct, the
NOTE: If a separate VCR setup code is not
listed, you can use the VCR
a separate VCR device or another device
page 9).
6. For future reference, write down the
working DVD Player/VCR combo
code in the below boxes:
Owner's Manual
DVD Player/VCR Code:
Brand Name:____________________
VCR Code (if used):
Brand Name:_____________________

SEARCHING FOR YOUR CODE

If your device does not respond to the
remote control after trying all codes
listed for your brand, or if your brand
is not listed at all, try searching for your
code. For example, to search for a code
for your TV:
1. On the remote control, press TV once.
2. Press and hold SET
light) blinks twice, then release SET.
9 9 1
4. Aim the remote control at the TV
and slowly alternate between pressing
POWER and TV
turns off.
NOTE: In the search mode, the remote
control will send IR codes from its library
to the selected device, starting with the
most popular code first.
5. To lock in the code, press and release
SET
6. To search for the codes of your other
devices, repeat steps 1 through 5, but
substitute the appropriate device key
for the device you are searching for.

CHECKING THE CODES

If you have set up the remote control
using the Searching For Your Code
procedure (above), you may need to find
out which four-digit code is operating
your equipment.
7