Air Filter Element Change Procedure; Separator Cartridge Change Procedure; Cooler Cleaning Procedure - Ingersoll Rand UP5S 11 Instalación, Operación Y Mantenimiento

7�� Replace plug in drain valve��
8�� Refill the machine following the "top up coolant"
procedure above�� After initial fill, to purge any
airlocks, the machine should be run for a few
minutes cycling between load and no load, before
checking that the level is correct��
9�� Replace and tighten coolant fill cap��
COOLANT FILTER CHANGE PROCEDURE

1�� Stop the machine, electrically isolate and vent all
trapped pressure��
2�� Loosen filter with the correct tool��
3�� Remove the filter from the housing��
4�� Place the old filter in a sealed bag and dispose of in a
safe way��
5�� Clean the mating face of the housing taking care to
avoid any particles entering the machine��
6�� Remove the new Ingersoll Rand replacement filter
from its protective package��
7�� Apply a small amount of lubricant to the filter seal��
8�� Screw the new filter down until the seal makes
contact with the housing, then hand tighten a
further half turn��
9�� Start the compressor and check for leaks��

AIR FILTER ELEMENT CHANGE PROCEDURE


1�� Stop the machine, electrically isolate and vent all
trapped pressure��
2�� Unscrew the retaining cap and withdraw the old
element��
3�� Fit the new element��
4�� Replace the retaining cap��

RELEASED 20/Jul/2016 17:56:55 GMT
MAINTENANCE

SEPARATOR CARTRIDGE CHANGE PROCEDURE


1��
2��
3��
4��
5��
6��
7��
8��
This unit is not designed or intended to operate
when contaminated with silicone�� Lubricants,
greases or other items containing silicone should
not be used on this unit��

COOLER CLEANING PROCEDURE


1��
2��
3��
4��
Stop the machine, electrically isolate and vent all
trapped pressure��
Loosen separator cartridge with the correct tool��
Remove the cartridge from the housing; place it in a
sealed bag and dispose of it safely��
Clean the mating face of the housing��
Remove the new Ingersoll Rand replacement
cartridge from its protective package��
Apply a small amount of lubricant to the cartridge
seal��
Screw the new cartridge down until the seal makes
contact with the housing, then hand tighten a
further 1/4 turn��
Start the compressor and check for leaks��
CAUTION
Stop the machine, electrically isolate and vent all
trapped pressure��
Remove the top cover to obtain access to the cooler��
Clean the cooler��
Rebuild in reverse order��
80448418 Rev.C