Troubleshooting - Pentair BOOST-RITE Manual De Instalación / Guía Del Usuario

Use the following information to resolve possible issues with your booster pump.
PROBLEM POSSIBLE CAUSE
Pump motor does not run. Power is off.
Circuit is tripped.
Fan guard pushed against fan.
Pump is in OFF mode in a timer
controlled circuit.
Motor terminal wiring is incorrect.
Impeller is blocked by debris.
Reduced pump flow and/ Inlet and outlet line is blocked.
or cleaner runs too slow.
Motor is wired improperly.
Air pockets or leaks in suction line.
Clogged impeller.
Clogged filter.
Motor Over-Heating. Incorrect electrical supply connections.
Wiring to pump is under-sized.
Power company supply voltage is
too low.
Inadequate motor ventilation.
Mechanical Noise. Pump vibrating or making loud noise
on equipment pad.
Cavitation.
Fan guard pushed against fan.
CORRECTIVE ACTION
Check power and reset.
Check circuit breaker and reset.
Move fan guard back into place with
hammer and screwdriver.
Check timer mode.
Have terminal connections checked by
an electrician.
Clear debris from impeller.
Check for debris.
Open line restriction.
Check terminal connection.
Check suction piping and valves.
Make suction piping is at least 2' (51
mm) in diameter.
Clear debris from impeller. Refer to
pages 11-12 for instructions on removal.
Shut down pump and clean filter.
Check motor terminal.
Tighten any loose connections.
Increase wiring size.
Check line voltage; if less than 90% or
more than 110% of rated voltage, consult
licensed electrician.
Remove any restriction to air flow to
reduce ambient temperature.
Check pump location; bolt pump to
concrete pad.
Make sure suction and discharge pipes
are adequately supported.
Improve suction conditions.
Increase pipe size.
Increase discharge pressure.
Remove bends or kinks in flexible hose
piping.
Move fan guard back into place with
hammer and screwdriver.
BOOST-RITE Universal Booster Pump Installation and User's Guide
™

TROUBLESHOOTING

9