Superwinch S2500 Manual Del Propietário página 2

I N T R O D U C T I O N
Thank you for purchasing an S2500 winch from Superwinch. It has been
designed and manufactured to provide years of trouble-free operation.
We hope you will be pleased with its performance. If you are not, for any
reason, please contact our Customer Service Department:
(860) 928-7787 USA; +44 (0) 1822 614101 England.
When requesting information or ordering replacement parts; always give the
following information:
1. Winch Part Number (i.e. 02510, 02512, 02513, 02532, 02533)
2. Serial Number (found on housing)
3. Part Number (found in Replacement Parts List section)
4. Part Description
Please read and understand this Owner's Manual before installing your S2500
winch. Pay particular attention to the General Safety Information. Your
S2500 winch is a very powerful machine. If used unsafely or improperly, there
is a possibility that property damage or personal injury could result. We have
included several features in the S2500 winch to minimize this possibility;
however, your safety ultimately depends on your caution when using this
product.
Correct installation of your S2500 winch is a requirement for proper
operation. If you intend to install your S2500 winch on the front end of your
vehicle, USE THE S2500 MOUNTING (FITTING) KIT which has been designed
and manufactured by Superwinch to accommodate your winch and fit your
vehicle.
Please Note: The Superwinch model S2500 winch is designed primarily for
front mount vehicle use and for other intermittent duty general use. This
winch is not designed to be used in industrial or hoisting applications and
Superwinch does not warrant it to be suitable for such use. Superwinch man-
ufactures a separate line of winches for industrial/commercial use. Please con-
tact our Customer Service Department for further information.
Note the electrical requirements of the S2500 winch you have purchased.:
Part Numbers 02510, 02512, 02532
Part Numbers 02511, 02513, 02533
Congratulations on your choice!
ROLLING LOAD CAPACITIES
Slope*
Lbs.**
kg**
Ratings assume a 10% coefficient of friction.
* A 10% slope is a rise of one foot in ten feet. Slope in approximate degrees is shown above.
** All loads shown are for single-line operation. Double-line operation with optional pulley block
approximately doubles capacity of winch.
2
Pay particular attention to the caution and warning notes
preceded with the symbols shown here. The notes contain
advice for your protection.
10% (6º)
12,563
5,698
12-volt DC system Only
24-volt DC system Only
20% (11º)
8,503
3,857
30% (17º)
6,527
2,961
100% (45º)
3,213
1,457