General Overview; Top Tether - Kindcomfort KBI 012 Manual De Uso

14. in the event of an emergency it is important to quickly remove the
child from the safety seat. to this end the clasp is not designed to be
tamper-proof and the child should be instructed not to play with it.
15. Luggage or other objects that may cause harm should be correctly
secured.
16. inspect the safety straps periodically to ensure they are not worn,
paying special attention to the anchor points, the seams and the
adjustment systems.
17. the safety seat's rigid and plastic elements should be positioned and
installed so that they cannot be trapped by a moving seat or a door
during everyday use of the vehicle.
18. always ensure that the straps securing the safety seat are tightened
and the straps securing the child fit snugly around the body. always
check that the straps are not twisted or knotted.
19. the seat should be replaced after undergoing the violent stresses
associated with an accident.
20. Do not use anchor points that are not listed in the instruction manual
and indicated on the seat.
21. Do not allow the seat to come in contact with corrosive substances
such as battery acid.
22. this child safety seat should not be used without its cover. Covers
should not be replaced with other covers not recommended by the
manufacturer as the cover forms an integral part of the seat.
23. read the instruction manual carefully before installing the seat.

1. general overvIeW

a. headrest height regulator.
b. headrest.
c. Diagonal belt guides
(group 2).
d. shoulder pads.
e. harness straps.
f. harness buckle.
g. Harness adjustment strap.
h. reclining lever.
20
I. isofix system regulator.
J. Harness adjustment button.
K. abdominal belt guides.
l. isofix system unlock button.
m. isofix system arms.
o. top tether.
P. shoulder pads connector.
Q. Diagonal belt guides
(group 0+).
2. vehIcle InstallatIon PoInts
Where:
In the vehicle rear seats.
Please, do NOT install the safety seat in forward seats except for the
following cases:
1. whenever the vehicle does not count with rear seats.
2. when all rear seats are already occupied by children exceeding
135 cm height.
3. when it is not possible to install all child restraints systems in the rear seats.
hoW:
grouP 0+ / Install rearward facing.
grouP 1 / Install forward facing.
grouP 2 / Install forward facing.
en asientos con:
anclajes IsofIX (entre el asiento y el respaldo) y puntos de
anclaje top tether (por ejemplo en la bandeja, en el suelo
o detrás del respaldo) y cinturón de 3 puntos (cinturón del
vehículo).
notIce:
the child seat must only be used in this seat If it has a lap and
diagonal belt (3 points).
3. InstallIng the car seat. grouP 0+
grouP 0+ only. 0 to 10 months
notIce
(0-10 Kg)
1. Check the seat is ready to be installed rearward facing (Group
0) as shown in fig. 3.1. Recline the seat fully. Pull the lever
forward and adjust the angle of recline to position 4 without
releasing the lever. release the lever when the seat is in the
desired position.
2. place the seat in the back seat of the vehicle and contrary to
the direction of travel (fig. 3.2).
1
2
(h)
21