Installing The Child Seat. Group - Kindcomfort KBI 012 Manual De Uso

9. Take the Top Tether and press the Top Tether adjuster to stretch the
strap.
10. Hook the safety clasp to the top tether anchor point recommended
in your vehicle instruction manual (fig. 6.5).
ImPortant! Make sure not to use the luggage clip
instead of the top tether anchor clip. look for this
symbol in your vehicle:
11. to tighten the top tether, take up any slack by pulling the free
end of the belt through the Top Tether adjuster (fig. 6.5). The Top
tether will be correctly tightened when the green tension indicator
extends 1 mm (fig. 6.7).
uninstalling the Isofix arms
1. to release the ISOFIX arms, pull the button on the anchors to
unlock them until the indicator turns from green to red color. this
will release the child seat (fig. 6.8).
7. PlacIng the chIld In the seat. grouP 1
to seat the child correctly follow the steps described in chapter 4.
8. removIng the harness and safety bucKle
1. removing the 5 point harness and the safety buckle
1. loosen the harness straps by pulling them gently while pressing the
harness adjustment button
2. loosen the harness straps from the back of the seat, freeing them
from the harness connector (n). repeat the operation with the
shoulder straps connector
3. pull the harness straps from the front to free them from the seat
back. (fig.8.3).
4. take off the safety buckle, passing the retention plate through
the seat base slots (fig. 8.4).
24
(J) (fig.8.1)
(P) (fig. 8.2).
2. removing the fabric cover
1. put the headrest in the higher position.
2. take off the headrest fabric cover.
3. take off the fabric cover from the car seat.

9. InstallIng the chIld seat. grouP 2

before installing the seat for group 2, the seat harnesses (e),
harness protectors ( d) and buckle
this, follow chapter 8, section 1.
1. Ensure the seat is not in a reclined position (the indicator should
be in position 1) and is ready to install in forward position
(Group 2). pull the lever (h)
recline to position without releasing the lever. release the lever
when the seat is in the desired position.
2. place the child safety seat in the back seat of the vehicle facing
in the direction of travel.
10. PlacIng the chIld In the seat. grouP 2
1. According to the child's height the headrest can be adjusted up
or down. place your hand on the headrest height regulator
and pull while pulling the seat down with the other hand so it
does not move (9.2).
2. place the child in the seat.
3. pass the vehicle seat belt and buckle the vehicle seat belt until
you hear a click (fig. 9.3 and 9.4).
4 pass the diagonal part of the belt through the diagonal belt guide
on the headrest until it is fully extended and not twisted (fig. 9.5).
6. take up the slack by pulling the abdominal section of the belt until
it is as tight-fitting as possible.
7. it is important to ensure that the abdominal belt is worn low
down, so that the pelvis remains firmly fixed.
As the child grows, the headrest height must be adjusted. In order
to do this, the steps outlined in point 10.1 must be followed.
(f) must be removed. Please, for
forward and adjust the angle of
(a)
(c)
25