Reliable ARIA 350SP Manual De Instrucciones página 10

FABRIC NYLON SILK WOOL
65°C 95°C 125°C 155°C
TEMPERATURE
149°F 203°F 257°F
STEAM No No Yes Yes
4. Plug in and press the power on/off button (F) located on the LED digital touch
screen control panel. A power on indicator light (H) will appear. Be sure that
the pressing plate (I) is in an open position when the unit is initially turned on.
5. Use the mode buttons (B) to choose the fabric setting. It may take a few
minutes to reach the chosen temperature when decreasing or increasing
settings.
NOTE: It takes approximately 12 minutes for the press to reach the linen
temperature.
WARNING: During initial use, or after a long period of time without use, press the
steam burst button (A) continuously for several seconds to clear the pressing
plate of residual water or calcium buildup in the system before use.
CAUTION: Be sure to examine the garment label before selecting a fabric
setting. If you cannot determine a fabric type, select the lowest setting and
increase as needed. It is best to start with the most delicate fabrics first to
avoid damage to your fabrics.
6. Once the press has reached the desired temperature, the green fabric setting
lights will stop flashing. Begin pressing. Be sure to use the provided pressing
cushion (M) to flatten out gathered areas such as sleeves, darts and yokes. If
needed, use the spray bottle (N) for dampening the fabric before pressing.
7. Pull down the pressing handle (I) and press the pressing plate (H) and the
ironing board (J) together. Hold for a few seconds, then lift to separate the
pressing plate (I) and ironing board (J).
8. To use steam, adjust the fabric selection mode to the wool, cotton or linen
settings. The steam ready light (D) will appear and you will be able to press
the steam burst button (A) for steaming your garments.
9. Pull down the pressing handle directly above the garments (about 1 to
2 inches above the fabric) and press the steam burst button (A). Press
the garment. DO NOT activate the steam burst button (A) with the unit
completely closed; you may damage your press.
CAUTION: Do not hold down the press for longer than 5 seconds. If using the steam
burst button, do not fully close the press down onto fabric. If you hold down the
press for too long, you may cause your garments to wrinkle because they are too
hot. If this should happen, spray down the garment with water and start over.
07
COTTON LINEN
185°C
311°F 365°F
Yes