Reliable ARIA 350SP Manual De Instrucciones página 12

BASIC IRONING
TABLE CLOTH
Fold the length of the fabric in either half or thirds and place on the ironing board.
Accordion pleat the length on the ironing board and move the pleated item into
the large open space behind the ironing board.
Move the tablecloth towards you, then press.
Continue moving forward until the entire item is pressed.
To store, fold it and place it on the ironing board and close the press. Apply
minimal pressure. If necessary, refold the tablecloth to press any areas that were
hanging off the sides of the ironing board. Repeat the pressing procedure.
Hint: Use the same method for most large items, such as duvet covers, bed sheets,
pillowcases, table runners, towels, blankets, quilts, etc.
PANTS
Waistband- Place the top of the pants on the press. Press the pressing board
down over the pants to the ironing board. If using the pressing cushion, place the
waistband of the pants around the board on top of cushion. Arrange pleats. Rotate
pants to press entire waistband.
Side Pockets- Slide pockets over the pressing cushion and over the pressing board
then press.
Inseam- Place the inside of the crotch area on the board facing up. Align with the
slanted left side of the board. Press.
Legs- Place the top of the pant leg half way on the ironing board. Press the front
crease. Then, place the bottom of the pant leg half way on the ironing board. Allow
the hem or cuff to hang off the end of the board. Press. Follow the same method
for pressing back crease.
Note: The hems of the pants can be pressed by placing them both on the ironing
board and applying a small amount of pressure.
SHIRT AND BLOUSES
Yoke- Arrange the shoulders around the slanted left side of the board. Let the
collar hang off the edge. Press.
Cuffs- Place the cuffs and plackets around the edges of the ironing cushion.
Arrange any pleats. Press.
Sleeves- Place the garment to the left side of the press with the collar towards
you. Place the first sleeve on the ironing board with the curve of the garment fit-
ted to the slanted left side of the board (the second sleeve will lay in front of the
press off the board). Press. Remove the first sleeve and place the second sleeve
on the board. Press.
09