Morningstar EcoBoost MPPT EB-MPPT-20 Manual De Instalación, Operación Y Mantenimiento página 9

With DIP 1 ON, the EcoBoost MPPT will follow a dusk-to-
dawn lighting schedule.
Switches 2, 3: System Voltage
Three (3) system voltage configurations are available as shown
in the table below:
System Voltage
Auto
12
24
NOTE: Before connecting the battery, measure the open-circuit
voltage. It must be over 10 volts to start the controller. If the
system voltage Settings Switches are set to Auto-detect, battery
voltage over 15.5V will be detected as a 24V nominal battery,
and the unit will charge accordingly. The 12/24V auto selection is
only done at start-up, and the detected system voltage will never
change during operation.
Generally, the specfic system voltage is known, and it is best
to set DIPs 2,3 accordingly; the auto-detect setting should be
used only in rare circumstances.
Switches 4, 5, 6: Battery Type Selection
Preset EcoBoost MPPT battery charging options are shown in
table 3-1 below. All voltage settings listed are for nominal 12
volt batteries.
Multiply the voltage settings by two (2) for 24 volt systems.
NOTE: These settings are general guidelines for
use at the operator's discretion. The EcoBoost MPPT
can be programmed to satisfy a wide range of charging
parameters. Consult the battery manufacturer for optimal battery
charge settings.
12 Installation
Switch 2 Switch 3
OFF OFF
OFF ON
ON OFF
DIP
Absorp. Float
Switch Battery
Stage Stage
Settings Type
(volts) (volts)
4-5-6
off-off-off 1 - Sealed* 14.00 13.50
off-off-on 2 - Sealed* 14.15 13.50
off-on-off 3 - Sealed* 14.30 13.50
off-on-on 4- AGM/Flooded 14.40 13.50
on-off-off 5 - Flooded 14.60 13.50
on-off-on 6 - Flooded 14.70 13.50
on-on-off 7 - L-16 15.40 13.40
on-on-on 8 - Custom Custom Custom
* "Sealed" battery type includes gel and AGM batteries
Table 3.1. Battery charging settings for each selectable battery type
Switch 7: Battery Equalization
Mode
Manual Equalization
Auto Equalization
Switch 8: Reserved for Future Use
EcoBoost MPPT Operator's Manual
Equalize Absorp. Equalize Equalize Equalize
Stage Time Time Timeout Interval
(volts) (mins) (mins) (mins) (days)
150
14.40 150 60 120 28
14.60 150 60 120 28
15.10 180 120 180 28
15.30 180 120 180 28
15.40 180 180 240 28
16.00 180 180 240 14
Custom Custom Custom Custom Custom
Switch 7
OFF
ON
13