Electrical Safety - Breg Polar Care Wave Instrucciones De Uso

ELECTRICAL SAFETY

• When using or cleaning the Polar Care Wave, avoid flammables and oxidizers.
Flammables
• Even though the Polar Care unit is designed to hold and pump water, the
• Do not handle the power supply or electrical cord with wet hands.
Keep electrical
• Always keep the unit in a place where the connections will not fall into water
components dry
and free of debris
• If the electrical connections fall into water, do not touch any part of the product.
• Unplug only at dry electrical connections.
Power supply • Use only the power supply provided with the Breg Polar Care Wave unit.
• Keep the cord and power supply away from heated surfaces.
• Never operate this product if it has a damaged cord, power supply, or plug,
• If the cord, power supply, or plug is damaged, unplug and contact Breg
• This Polar Care Wave unit may cause electromagnetic or other interference with
Electromagnetic
interference and
emissions
• Portable RF communications equipment should be used no closer than 12
• Using accessories or a power supply other than those provided could result in
Disposal
This product contains electrical components and can not be discarded in standard waste.
Dispose of product according to local regulations.
22
Do not use in places with flammable vapors or gases (e.g., flammable
anesthetics), high oxygen concentrations, or other oxidizers (e.g., nitrous oxide).
electrical components of the unit and power supply must be kept dry.
(e.g., a tub, sink, etc.).
Model number is listed in Electrical Specification section on page 20.
which could result in electric shock.
Customer Care.
other electrical devices. Avoid using the Polar Care Wave unit adjacent to or
stacked on other equipment because it could result in improper operation of the
unit or the other equipment.
inches (30 cm) to any part of the Polar Care Wave unit, doing so may result
in product performance degradation.
increased electromagnetic emissions or decreased electromagnetic immunity
of the unit and can result in unit malfunction.