KOBE CH-191 Serie Instrucciones De Instalación Y Manual De Operación página 11

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Ductwork Installation
5.
Use aluminum or steel pipe to connect the
6" round plastic exhaust on the hood to
the ductwork above.
make all joints secure and air tight. Refer
to Figure 4.
To convert ductwork to 7" round, attached
6.
7" round adapter (provided) to the 6"
round plastic exhaust.
Wiring to Power Supply
SAFETY WARNING
RISK OF ELECTRICAL SHOCK.
RANGE
HOOD
MUST
GROUNDED.
MAKE SURE THIS IS DONE
BY
SPECIALIZED
ACCORDANCE WITH
NATIONAL
AND
CODES.
BEFORE CONNECTING WIRES,
SWITCH POWER OFF AT SERVICE PANEL
AND LOCK SERVICE PANEL TO PREVENT
POWER
FROM
BEING
ACCIDENTALLY.
7.
Connect the electrical wires.
-
Connect three wires (black, white and
green) to house wires and cap with wire
connectors. Connect according to color:
black to black, white to white, and green
to green as shown on Figure 5.
-
If necessary to hide the electrical wire
connections, push wires back into the
wiring box. Access the wire connections
underneath the hood. Make sure wires
do not slip between motor or any
moving parts to prevent any damage.
Accessories
8.
Attach oil tunnel. Refer to Figure 6.
Refer to Figure 7.  Slide the baffle filter
9.
into the hood.
 Slide forward.
upward.
downward.  Fit into place.
10.
For bottom casing, repeat above steps.
Refer to page 16.
Final Assembly
11.
Turn power ON in control panel. Check
all lights and fan operation.
12.
Make sure to leave this manual for the
homeowner.
Use duct tape to
THIS
BE
PROPERLY
ELECTRICIAN
ALL
APPLICABLE
LOCAL
ELECTRICAL
SWITCHED
 Push the baffle filter
 Pull
Figure 5
Figure 6
IN
ON
Figure 7
9

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Ch9130sqbCh9136sqbCh9142sqbCh9148sqb

Tabla de contenido